User Manual

ManualsBrandsTii ManualsEquipment3800 Series

141 Rodeo Drive tii 3800 Series

Edgewood, NY 11717 COCOT Mounting Base

Toll Free 888.844.4720 tii P/N: 92213401

www.tiinettech.com 01/08 Rev E

INSTALLATION NOTE

1. GENERAL

The tii 3800 Series COCOT (Customer Owned Coin

Operated Telephone) provides a demarcation point

between the telephone service provider network and

the subscriber’s telephone wires. The Network

Interface Device (NID) may contain gel sealed station

protectors (tii Angle Drivers), or other primary station

protectors such as tii’s 355, 356, 127, etc., and sealed

subscriber bridges (tii 95S Series). These primary

surge protection modules provide primary electrical

protection for subscribers. The tii 95S Series provides

subscriber connections and a demarcation test

access point. Each can terminate up to four

subscriber extension line connections which will

automatically disconnect when the customer uses the

RJ-11 port for testing.

NOTE: See separate installation note if the unit is

equipped with tii 95S Series ADSL POTS Splitter module.

Each Angle Driver module can connect one pair of 18-

24 AWG (1.02-0.51mm) central office (c.o.) wire and

one pair of 22-24 AWG (0.65-0.4mm) subscriber

bridge wires. Connections are created with insulation

displacement connection (IDC) blades and are

environmentally sealed.

The NID housing is constructed from rugged, heat and

solvent resistant, UV stabilized materials.

CAUTIONS AND WARNINGS

Use company-approved safety practices and

equipment.

Only solid conductors can be used for connecting to

the Angel Driver and the tii 95S Series Subscriber

Bridges; Do Not Use Stranded Wire.

Stranded or solid wires can be used on binding post

termination primary protectors.

Do not strip insulation from conductors when

terminating to an IDC connector.

If the hook up wire, OSP wire, or central office cable

is physically larger than 22 AWG, a fusing conductor

of 22 AWG or smaller solid copper wire with

thermoplastic insulation must be used. Install the

fuse link per local practices and approval agencies.

This installation note may be used for binding post

terminating primary protectors

2. INSTALLATION

The 3800 COCOT NID Series is equipped for screw

fastener mounting.

Figure 1

Summary of content (2 pages)

PAGE 1
tii 3800 Series 141 Rodeo Drive Edgewood, NY 11717 Toll Free 888.844.4720 www.tiinettech.com COCOT Mounting Base tii P/N: 92213401 01/08 Rev E INSTALLATION NOTE Figure 1 1. GENERAL The tii 3800 Series COCOT (Customer Owned Coin Operated Telephone) provides a demarcation point between the telephone service provider network and the subscriber’s telephone wires.
PAGE 2
To mount to wooden pole or wall, install two screws through the housing mounting tabs. Secure them to the required service. Pull lightly on all wires to verify connection. Perform all customary tests. It also contains a magnetic base for mounting to metallic surfaces. Prepare and Route Cables, Grounding Route the central office (c.o.) wire to the housing. If the cable is shielded, remove 1” of sheath and attach the ground lug to the shield. Route the subscriber wire to the housing.