Installation Guide

Step 1

Remove the four screws and discharge the white clamp ring. Install a bead of urethane onto the clamp ring and

around each screw as show in picture two. Screw the adaptor on using the screws from the clamp ring.

Step 3

Mix a modied thin-set mortar suitable for the suboor as per manufacturer specication. Use a 3/8” square

notched trowel and apply thin-set mortar to the oor and backside of shower pan. Assure that the thin-set is

troweled in the same direction. Spreading the thin-set with a square notched trowel will assure full

coverage. Set the shower pan into place.

Step 4

Protect the shower pan by using a double layer of cardboard. Take two bags of thin-set and place them in the

drain area for extra weight to assure the pan slope stays at a minimum of 2%. The drain cover will be screwed

onto the pan just before tile installation.

Suboor Prep

You must begin with a dry and structurally sound suboor. If water damage, rotting, or any other structural

defects are present, you MUST repair prior to installing your new shower pan. A clean and level suboor is

required for a successful installation. After cleaning the suboor, use a level to check the suboor. The suboor

MUST be level so that the shower pan will drain correctly.

Note: a self-leveling mortar can be used to level the suboor.

Step 2

Pret the shower pan and cut to t the shower area, if needed. You can cut the foam board with a utility knife or

a circular saw. Install the cone on the shower pan.

844-668-6420 technicalsupport@tiliteusa.com www.tiliteusa.com

CLAMP RING

SQUARE DRAIN SHOWER PAN INSTALLATION GUIDE

PAGE 1
SQUARE DRAIN SHOWER PAN INSTALLATION GUIDE CLAMP RING Subfloor Prep You must begin with a dry and structurally sound subfloor. If water damage, rotting, or any other structural defects are present, you MUST repair prior to installing your new shower pan. A clean and level subfloor is required for a successful installation. After cleaning the subfloor, use a level to check the subfloor. The subfloor MUST be level so that the shower pan will drain correctly.
PAGE 2
SQUARE DRAIN SHOWER PAN INSTALLATION GUIDE CONNECTITE® DWV FITTING Subfloor Prep You must begin with a dry and structurally sound subfloor. If water damage, rotting, or any other structural defects are present, you MUST repair prior to installing your new shower pan. A clean and level subfloor is required for a successful installation. After cleaning the subfloor, use a level to check the subfloor. The subfloor MUST be level so that the shower pan will drain correctly.
PAGE 3
SQUARE DRAIN SHOWER PAN INSTALLATION GUIDE RUBBER GASKET MUST HAVE ACCESS FROM THE BOTTOM Subfloor Prep You must begin with a dry and structurally sound subfloor. If water damage, rotting, or any other structural defects are present, you MUST repair prior to installing your new shower pan. A clean and level subfloor is required for a successful installation. After cleaning the subfloor, use a level to check the subfloor. The subfloor MUST be level so that the shower pan will drain correctly.