Warranty
Application is hereby made for the transfer of the KP warranty to:
___________________________________________________________________________
(PRINT NAME)
The new owner of the premises upon which the original KP vinyl siding installation
was made. The undersigned certify the following: (PLEASE PRINT CLEARLY)
___________________________________________________________________________
(NAME OF FORMER OWNER)
___________________________________________________________________________
(LOCATION OF INSTALLATION ADDRESS)
___________________________________________________________________________
(CITY) (STATE/PROVINCE) (ZIP/POSTAL CODE)
___________________________________________________________________________
(DATE OF INSTALLATION) (DATE OF TRANSFER)
___________________________________________________________________________
(SIGNATURE OF FORMER OWNER) (DATE)
___________________________________________________________________________
I expressly assent to the terms of the KP warranty.
___________________________________________________________________________
(SIGNATURE OF NEW OWNER) (DATE)
Place this card in an envelope and mail to:
KP Building Products
402 Boyer Circle
Williston, VT 05495
THE VINYL SIDING INSTITUTE’S IMPORTANT FIRE SAFETY
INFORMATION STATEMENT IS AS FOLLOWS:
Exterior vinyl building materials require little maintenance for many years. Nevertheless,
common sense dictates that builders and suppliers of vinyl products store, handle and
install vinyl materials in a manner that avoids damage to the product and/or structure.
Owners and Installers should take a few simple steps to protect vinyl building materials
from fire.
TO HOME AND BUILDING OWNERS:
Rigid vinyl siding is made from organic materials and will melt or burn when exposed
to a significant source of flame or heat. Building owners, occupants and outside
maintenance personnel should always take normal precautions to keep sources of fire,
such as barbecues, and combustible materials, such as dry leaves, mulch and trash away
from vinyl siding.
TO THE BUILDING TRADES, SPECIFIERS, PROFESSIONALS AND TO
DO-IT-YOURSELF INSTALLERS:
When rigid vinyl siding is exposed to significant heat or flame, the vinyl will soften,
sag, melt or burn, and may thereby expose material underneath. Care must be exercised
prior to installation when selecting underlayment materials because many underlayment
materials are made from organic materials. All building materials should be installed in
accordance with local, state and Federal building codes and fire regulations.
CARE AND MAINTENANCE
While KP vinyl siding remains virtually maintenance free, it will become dirty
as any other product which is exposed to atmospheric conditions. Normally,
your KP vinyl siding can be cleaned satisfactorily through the use of an ordinary
garden hose. If stubborn stains cannot be removed with water, the following
procedure should be used:
1. Equip the garden hose with a soft bristled, long handle car brush.
2. Where soil is of a stubborn nature, the following cleaning solution
works well:
• 1/3 cup household detergent
• 2/3 cup trisodium phosphate
• 1 gallon of water
In certain geographic areas where mildew may be a problem, substitute one
quart of 5% sodium hypochloride (household bleach) for one quart water in the
above formula.
Where the house is extremely dirty, it is recommended that you start
washing from the bottom and go to the top, rinsing frequently. Cleaning
solutions should be permitted to stand on the surface of the siding for several
minutes before rinsing.
Application for Transfer
ABTCO Perfection® Shingles Siding
LIFETIME LIMITED WARRANTY
L L W
Perfection
Shing les
ABTCO is a registered trademark of KP Building Products.
Perfection
®
Shingles is a trademark of KP Building Products.
©2018 KP Building Products. All rights reserved.
www.abtco.com
KPPSWR-18