Use and Care Manual

Terrain, Tropical
& Legacy Collections
Cleaning procedures
In preparation for spot cleaning as well as full surface cleaning, you will
need a bucket of water, one of the recommended scrub brushes with an
extension handle and one of the recommended cleaners.
Work in small manageable areas. Avoid cleaning in direct sunlight, the UV
and heat will dry the surface quickly as you attempt to clean.
Saturate the area with one of the recommended cleaners and allow the
cleaner to soak for 30-60 seconds. Do not allow the cleanser to dry or
evaporate before scrubbing. Rinse area thoroughly with water after
scrubbing.
Using the recommended brush and extension handle, scrub using
moderate downward pressure, first scrubbing in the direction of the grain
and then against the grain getting into the surface texture. Do not allow
the treated area to dry before rinsing thoroughly as this will allow dirt
residue to dry in the surface texture.
Thoroughly rinse the treated area with clean water, then allow the area
to completely air dry. Note that any residual cleaner residue can leave a
difficult to remove surface film, always rinse thoroughly and never allow the
cleaner to dry/evaporate on the surface prior to rinse.
cleaned not cleaned