Installation Guide

Page 12
Care and Cleaning
With proper installation and care, TimberTech products will provide years of outdoor living pleasure.
For most current recommendations, visit http://www.timbertech.com/warranty-and-care/care-and-cleaning/default.aspx
To clean Earthwood Evolutions we recommend the
following methods:
*Keeping an unsoiled deck surface will make cleanup after a
spill much easier.
1. Immediately wipe the soiled area and remove as much of
the spill as possible.
2. If the spill consists of an abrasive substance, blot the spill.
Do not rub.
3. Soak the stained area with warm water and blot up with a
soft towel.
4. If the stain is still evident, mix a solution of mild dishwashing
detergent and warm water in a small bucket.
5. Using a clean towel or soft sponge, apply the soapy solution
to the stain and allow to stand for 3 minutes.
6. After the stain has soaked, attempt to wipe with a clean
towel or sponge.
For periodic maintenance cleaning, rinse deck thoroughly. A
soap and water solution can be used as needed.
Ice and Snow
As with any walking surface, TimberTech deck products may
become slippery in Winter weather. Take caution when walking
on the your TimberTech deck in these conditions.
For ice removal, either rock salt or calcium chloride may be
used without damage to the surface. However, either of these
products may leave a white residue, which may be removed by
either rinsing with water or a mild soap/water solution should
achieve this. Use care and caution to not damage the surface
of your deck when shoveling snow or ice off of it. Metal shovels
or plastic shovels with a metal leading edge may damage the
surface of your TimberTech Deck and are not recommended for
clearing snow from deck/porch surface.
Painting/Staining/Sealing
Although not recommended, TimberTech ReliaBoard, TwinFinish,
and DockSider products may be painted or stained. Once the
product is painted, stained or sealed, subsequent applications
will be necessary to maintain appearance. TimberTech does not
guarantee the performance of anything applied to the product.
Wait approximately 8-10 weeks or until the product has
completed its weathering process before painting or staining.
Clean your TimberTech surface prior to applying paint or stain.
Never paint or stain over surfaces that may contain dirt or
mildew. Always apply paints and sealers in accordance with the
manufacturer’s application instructions.
Stains and sealers that are recommended for use with the
above products are:
• Cabot Clear Solution-Oil Based
• Weatherall UV Guard Deck and Fence Coating
• Cabot Australian Timber Oil
Storage
Store TimberTech products under cover to maintain a clean
surface. If stored outdoors, they must be covered with a non-
translucent material.
• All products should be stored flat and on a dry surface.
• Stack units with banding and bottom supports aligned.
Handling
Although all TimberTech planks are made with low-maintenance
materials, each plank’s unique features require special care
and handling ensuring lasting beauty.
To maintain the beauty of TimberTech products please follow
these important guidelines when moving and working with
TimberTech:
• Never dump TimberTech materials when unloading.
• When carrying TimberTech planks, carry on edge for better
support.
• Do not slide planks against each other when moving them.
When removing them from the unit, lift the planks and set
them down.
• Do not slide tools or drag equipment across the top of the
planks during construction.
• Keep the surface of the planks free of construction waste
to prevent damage to the planks.
Care & Maintenance
Basic Cleaning Recommendations: TwinFinish,
ReliaBoard, and DockSider
Although TimberTech products are low-maintenance,
TimberTech recommends periodic cleaning to help maintain
the beauty of the product. For best results a cleaner like
Eco-friendly Corte Clean is recommended. Follow the
manufacturers’ application instructions.
• A power washer can be used when cleaning TimberTech
products. The recommended maximum pressure is 1500
psi from TimberTech decks. A fan tip nozzle should be
used along with the proper cleaning product. Spray in the
direction of the brush/grain pattern to avoid damaging
the product. Use caution not to damage the material and
always take the proper safety precautions when operating a
power washer.
Cleaners that are recommended for periodic cleaning or use
with TimberTech (ReliaBoard, TwinFinish, and DockSider) are:
• Super Deck Composite Deck Cleaner
• Corte Clean
• E Z Off Composite Wood Cleaner
• Thompson’s Water Seal-Oxy Action