Installation Guide

Page 12
Care and Cleaning
With proper installation and care, TimberTech products will provide years of outdoor living pleasure.
For most current recommendations or to download a PDF, visit http://www.timbertech.com/warranty-and-care/care-and-cleaning
into the surface texture. DO NOT allow the treated area to dry
before rinsing throughly as this will allow dirt residue to dry in
the surface texture.
Thoroughly rinse the treated area with clean water, then allow
the area to completely air dry. Note that any residual cleaner
can leave a difficult to remove surface film. Always rinse
thoroughly and never allow the cleaner to dry or evaporate on
the surface prior to rinse.
Recommended Products for TwinFinish
®
,
ReliaBoard
®
and DockSider
™
Collections
Although TimberTech products are low-maintenance, we
recommend periodic cleaning to help maintain the beauty
of the product. TwinFinish, ReliaBoard, and DockSider are
composite products and cleaning is not the same as for capped
composite products.
These recommended products can be purchased at many
hardware stores including Lowe’s and Home Depot as well
as online. Always make sure to read the cleaning product
manufacturers specific information before using any product
on your TimberTech Deck and follow their instructions.
Power Washing
A power washer can be used when cleaning TimberTech
products. The recommended maximum pressure is 1500 psi
for TimberTech decks. A fan tip nozzle should be used along
with the proper cleaning product. Spray in the direction of
the brush/grain pattern to avoid damaging the product. Use
caution not to damage the material and always take the proper
safety precautions when operation a power washer.
Cleaner
The cleaners TimberTech recommends for periodic cleaning or
use with ReliaBoard, TwinFinish, and DockSider include:
• Wash Safe Spray and Clean Composite Deck Cleaner
• Resist Mist Composite Deck Cleaner
• Corte Clean
• Super Deck Composite Deck Cleaner
• Thompson’s Water Seal — Oxy Action
Dirt, Grime, Tannin and Mildew Stains:
TimberTech wood/plastic composite products are formulated
to inhibit mildew growth and minimize staining. Rinse off
your TimberTech products periodically with a hose. Even if it
appears clean, it is important to prevent build-up of pollen/
debirs. Mildew stains may occur where moisture, pollens, and/
or dirt are present. Mildew needs a food source to grow, which
can be grass, pollens, dirt, debris, wood and wood resins.
Recommended Products for Terrain,
Tropical and Legacy Collections
We know you want to keep your TimberTech Deck clean and
looking its best, so here are a few guidelines on the best
products and methods to use to keep your TimberTech Deck
looking great.
These recommended products can be purchased at many
hardware stores including Lowe’s and Home Depot as
well as online. Always make sure to read the cleaning
product manufacturers specific information before using
any product on your TimberTech Deck and follow their
instructions.
Brushes
The correct brush is very important so that it not only cleans
the surface, but also does not damage or dull the plank
surface. We recommend using either the Quickie
®
Bulldozer
Deck Scrub or a medium plastic bristle deck brush. DO NOT
use a natural fiber deck brush on capped composites as
they can dull the surface.
Cleaner
For general periodic maintenance cleaning, use a dilution
of mild liquid soap and water. Dawn Ultra
®
has shown
best results. For more difficult to remove dirt, mud, clay,
or surface contamination, use an all purpose cleaner like
Chomp
®
Pro Gutter Cleaner or Zep
®
Fast 505.
*Note that composite deck cleaners such as Corte Clean
®
,
Thompson’s
®
Water Seal
®
— Oxy Action, Olympic
®
Deck
Cleaner, or other cleaners specified as composite deck
cleaners, in powder or liquid form, should not be used
with TimberTech Terrain, Tropical, or Legacy Collections.
TimberTech Terrain, Tropical, and Legacy Collection deck
planks are a capped composite material, the cap of these
products are not compromised of a wood/plastic composite.
Cleaning Procedures:
In preparation for spot cleaning as well as full surface
cleaning, you will need a bucket of water, one of the
recommended scrub brushes with an extension handle and
one of the recommended cleaners.
Work in small manageable areas. Avoid cleaning in direct
sunlight, the UV and heat will dry the surface quickly as you
attempt to clean.
Saturate the area with one of the recommended cleaners
and allow the cleaner to soak for 30-60 seconds. DO NOT
allows the cleanser to dry or evaporate before scrubbing.
Rinse area thoroughly with water after scrubbing.
Using the recommended brush and extension handle, scrub
using moderate downward pressure, first scrubbing in the
direction of the grain and then against the grain getting