Installation Guide

Page 8
4
a.
b.
c.
• Place the next plank into position against the fasteners.
Slightly raise the outer edge of the plank being installed and
slide it onto the fastener until the plank contacts the spacer
tab. When properly installed the inserted plank should be
in contact with the bent-forward spacer tab at the left end
of the clip. To achieve this use a scrap piece of decking at
least 24” in length and use it as a tamping block to drive the
plank further onto the clip and the screw will fully engage the
plank to the spacer tab if not already in contact. Do not use a
hammer or damage to the edge of the plank will occur.
• The last plank will need to have the outside edge attached
using the method described in Step #1. It may be necessary
to rip the last plank to fit.
COMPLETE INSTALLATION
5
HOW TO INSTALL AT BUTT JOINTS (UNLESS
USING TIMBERTECH
L-BRACKET)
Offset 1/4”
From Center
3
• Install provided screw at 45° angle through
the fastener and into the joist while applying
pressure on the fastener.
• Install one fastener and screw at each joist.
• Make sure fastener is in full contact with edge
of plank and the screw is holding the fastener
down tight to the deck board.
INSTALL CONCEALoc FASTENERS
CONCEALoc
®
Hidden Fastener
Joists at butt joints must be
doubled up for proper
fastener attachment.
• Install fasteners as detailed below.
Note that the two clips on the right
are shifted approximately 1/4” to
the right of center on the joists. If
this is not done the spacer tab may
fall within the gap of the butt joist.