Installation Guide

TOPLoc
™
Fascia Fastener
For use with TOPLoc Fascia Fasteners:
• Using the TOPLoc Fascia Bit, pre-drill 2” from the top and
bottom alternating a maximum of 12”. It is recommended
that screws are evenly spaced for best look.
• Set fascia in place. Be sure to follow proper gapping
requirements.
12”
• Drive TOPLoc fascia fastener 90 degrees with the
fascia surface so that the screw head is flush with the
surface. Do not completely torque down screw; screw
should serve as a hanging mechanism to allow for
expansion and contraction in the fascia. This will help
to prevent any undesired consequences to movement in
the fascia.
• Continue fastening in pattern described being sure
to work left to right or right to left. This will ensure
flatness of the fascia.
One box covers approximately 100 ln. ft. of fascia.
Installation also requires one TOPLoc Fascia Bit.
TOPLoc Fascia Fastener Installation Instructions
TimberTech Fascia Boards
Using screws with proper installation of TimberTech
Fascia provides the best long-term holding. TimberTech
recommends the use of TimberTech TOPLoc Fascia
Fasteners for best results.