Cat No.
1. GENERAL INFORMATION The unit utilises passive infrared technology to detect heat radiation of moving human bodies. Upon detection, the lamp will illuminate for a user-determined time period. An integral daylight sensor ensures night-only operation. The bulb supplied with the ECO36PIR is a class B (high efficiency) unit of 36W power consumption giving a similar but more diffuse light output to the lower efficiency 150W halogen units previously in use. PARTS INCLUDED - PIR flood light unit.
. INSTALLATION Before proceeding further fit the lamp to the flood light. To do this remove the 4 screws retaining the front glass and frame using a suitable cross point or flat blade screwdriver referring to Fig. 3. Remove the frame and glass being sure to retain the screw sealing rings and the frame gasket. Remove the spiral lamp from its box, ensure the lamp holders within the flood light are in the open position (see Fig. 4a).
CONNECTION Rotate the flood light so that the front glass looks back towards the wall, giving good access to the connector block. Take out the 2 screws holding the connector block in place and remove the connector block to ease wiring. Connect the mains supply cable to the terminal block as follows (see Fig. 7 connection diagram): NEUTRAL (Blue) N EARTH (Green/Yellow) LIVE (Brown) L Ensure the connections are secure. Replace the connector block and replace and tighten the 2 fixing screws.
SETTING UP FOR AUTOMATIC OPERATION The time Control determines how long the light stays on following activation and after all movement ceases. It is approximately linear so the mid point gives around 31/2 minutes delay from last detection. The required time can now be set. An approximate setting for the Lux (light) control to give operation after dusk only is between 2/3 and 3/4 of the way round from the Sun position toward the Moon position.
MANUAL OVERRIDE MODE The light can be switched on for longer time periods by use of the Manual Override Mode. This can be activated at night by using the internal wall switch or circuit breaker. Switch the internal wall switch/circuit breaker twice (on/off once) within 1/2 to 2 seconds. The unit will now illuminate continuously until it is switched back into Auto Mode.
6. TROUBLESHOOTING GUIDE PROBLEM SOLUTION o Lamp stays ON all the time at night. The unit may be suffering from false activation. Cover the sensor lens completely with a thick cloth. This will prevent the sensor from "seeing" anything. If the unit now switches off after the set time duration and does not re-activate, this indicates that the problem was caused by false activation. The problem may be solved by slightly adjusting the direction/angle of the sensor head.
3 YEAR GUARANTEE In the unlikely event of this product becoming faulty due to defective material or manufacture, within 3 years of the date of purchase, please return it to your supplier in the first year with proof of purchase and it will be replaced free of charge. For years 2 and 3 or any difficulty in the first year telephone our helpline on 020 8450 0515. This guarantee does not apply to the bulb. For assistance with the product please contact:- Helpline 020-8450-0515 or email helpline@timeguard.