Cat.
TG24 (Single) / TG44 (Twin) / TG64 (Triple) 24 Hour Segment Timeswitch Tough flame retardant casing 1 Time of day setting ring Time of day pointer Manual override switch Appliance socket Time control segments 1 segment = 15 minutes Push all segments downwards for ON, leave in upward position for OFF.
Programming Segment shown in OFF (upper) position Segment shown in ON (lower) position 2 Permanently ON Override switch Timed 1 Decide what times you would like the TG24/TG44 to switch ON and OFF. 2 Push all the segments downwards for the complete duration of an ON period and leave them all in the upper position for an OFF period (see diagram above left). The minimum switching interval is 15 minutes and this can be increased in 15 minute steps.
3 4 Bring the TG24/TG44/TG64 into the correct switching condition by manually turning the programme ring clockwise through a 24 hour cycle. 5 Check that the TG24/TG44/TG64 gives the correct switching pattern by turning the programme ring clockwise through a further 24 hour cycle. You will need to plug the TG24/TG44/TG64 into a live socket and plug in an appliance such as a lamp (switched on) into the TG24/TG44/TG64’s appliance socket to do this.
Override Switch This enables you to override the programmed settings for continuous ON operation. When the slide switch points towards the “ ” symbol the unit will operate normally as a timeswitch. When the slide switch points towards the “ ” symbol the unit will be ON continuously. 4 Points to note: • The segment dial can be turned even when the time controller is operating. • After a power failure, re-adjust the time controller to the correct time of day, turning the dial in a clockwise direction.
Uses 5 This timeswitch can be used to control domestic appliances such as heaters rated up to 13A (3KW) also tumble driers, washing machines and dishwashers (except those requiring a permanent supply and which have a push button start). The TG24/TG44/TG64 can be used with incandescent filament lamps rated up to a total of 400W. Can also be used with up to 100W of linear tube fluorescent or low energy lighting. The timeswitch is NOT suitable for use with SON or other discharge lamps.
Specifications Operating Temperature: Operating Voltage: Switch Rating: 6 0°C to 40°C 230V 50Hz 13A resistive (3kW) 2A inductive 400W filament lamps Control Type: 1B Conforms to Directives: 73/23/EEC & 89/336/EEC Can also be used with up to 100W of linear tube fluorescent or low energy lighting. Not suitable for SON or other discharge lamps.
Helpline 020-8450-0515 or email helpline@timeguard.com For a product brochure please contact: Timeguard Ltd. Victory Park, 400 Edgware Road, London NW2 6ND 020-8452-1112 or email csc@timeguard.com 67.058.151 (Iss.