W223 NA 222-0950012 W223_Analog2_NA_Cvr.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page ENii TIMEX® WATCHES Congratulations on purchasing your TIMEX® watch. Please read these instructions carefully to understand how to operate your Timex timepiece. Your watch may not have all of the features described in this booklet. For more information, please visit: Timex.
W223_Analog2_NA_EN.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 2 ENGLISH ENGLISH HOW TO START YOUR WATCH WATER AND SHOCK RESISTANCE To start your watch remove the plastic guard from under the crown, then press the crown in against the case. The second hand will begin advancing in onesecond intervals. If your watch is water-resistant, meter marking (WR_M) is indicated. Some deep-depth water-resistant watches require the setting crown to be screwed in to secure waterresistance.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 4 ENGLISH ENGLISH 2. Watch is not a diver watch and should not be used for diving. 3. Rinse watch with fresh water after exposure to salt water. 4. Shock-resistance will be indicated on the watch face or caseback. Watches are designed to pass ISO test for shock-resistance. However, care should be taken to avoid damaging the crystal.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 6 ENGLISH ENGLISH TO USE INDIGLO® NIGHT-LIGHT DIGITAL DISPLAY 1) PRESS pusher “B” to illuminate the entire dial (Both analog and digital). 1) The Digital display changes to each function every time you PRESS pusher “A”. (As illustrated below): TO USE NIGHT-MODE® FEATURE 1) PRESS and HOLD pusher “B” for 3 seconds until you hear a beep. 2) Pressing any pusher will cause the INDIGLO® night-light to illuminate and stay on for 3 seconds.
W223_Analog2_NA_EN.qxd 6/9/09 9:02 AM ENGLISH ENGLISH TO SET TIME / CALENDAR 1) PRESS pusher “A” to bring up TIME / CALENDAR display. 2) PRESS and HOLD pusher “D”. HOLD will display until second flashes. 3) PRESS pusher “C” to reset to second to “00”. 4) PRESS pusher “A” to let hour flash. 5) PRESS pusher “C” to advance hour. 6) PRESS pusher “A” and “C” as above to adjust tens of minutes, minute, year, month, date, day and 12/24 hour format. 7) PRESS pusher “D” to complete setting.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM ENGLISH ENGLISH WILL APPEAR FOR 3 SECONDS FOLLOWED BY THE CURRENT ALARM SETTING TIME AND TIME ZONE. TO SET DAILY ALARM 1) PRESS pusher “A” to bring up DAILY ALARM display: “ALARM” will appear for 3 seconds followed by the current alarm setting time and time zone. The ALARM mode symbol “AL” and the applicable time zone symbol “T1” or “T2” alternate to give complete information. 2) PRESS pusher “D” to let time zone flash. 3) PRESS pusher “C” to select time zone.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH TO SET DAILY ALARM OR CHIME ON/OFF 9:19 AM Page 12 ENGLISH TO USE COUNTDOWN TIMER 1) PRESS pusher “A” to bring up DAILY ALARM display. 2) PRESS pusher “C” to activate or deactivate daily alarm and chime accordingly. HOUR MINUTE SETTING MODE • • • • NOTE: a or C will appear or disappear according to daily alarm activation or deactivation. N or B will appear or disappear according to chime activation or deactivation.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH NOTE: When the timer counts down to zero it will beep for 20 seconds. To stop the timer beep, PRESS any pusher. “T” will appear to designate that the countdown timer is running. Countdown time up to 24 hours. PRESS and HOLD pusher “C” for 2 seconds in setting mode, to activate fast advance. TO USE CHRONOGRAPH FOR STANDARD MEASUREMENT: OR 1) PRESS pusher “A” to bring up CHRONOGRAPH display; “CH LAP” or “CH SPL” will appear. 2) PRESS pusher “C” to start timing.
W223_Analog2_NA_EN.qxd 6/5/09 HOUR Page 16 ENGLISH ENGLISH TO SET DUAL TIME: 9:19 AM MINUTE 1) PRESS pusher “A” to bring up DUAL TIME display. “T2” will appear beside the dual time. 2) PRESS and HOLD pusher “D”; “Hold” will display until hour flashes. 3) PRESS pusher “C” to advance hour. 4) PRESS pusher “A” to let month flash. 5) PRESS pusher “C” to advance month. 6) PRESS pusher “A” and “C” as above to adjust date, day, and to set 12 / 24 hour format. 7) PRESS pusher “D” to complete setting.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 18 ENGLISH ENGLISH MULTI-FUNCTION MODELS TO SET THE TIME 1) Pull crown all the way out and turn to correct time. 2) Push crown in to restart. Note: 24-hour display will set automatically. AB C CROWN POSITION TO SET THE DATE Instant date change: Your watch has a normal large face display and three small faces displaying date, day and 24-hour time. 1) Pull crown out one stop and turn CLOCKWISE until you reach correct date. 2) Push crown in to restart.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 20 ENGLISH ENGLISH DAY/DATE/AM/PM/ SUN/MOON MODELS NOTE: Remember to set time for am or pm (sun or moon). TO SET DATE: DATE DAY AB C CROWN POSITION 1) PULL out crown to “B” position. 2) TURN crown clockwise to correct date. 3) PUSH in crown to “A” position TO SET DAY: 1) PULL out crown to “C” position. 2) Advance time 24 hours to change the day. 3) PUSH in crown to “A” position AM/PM SUN/MOON TO SET TIME: 1) PULL out crown to “C” position.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM ENGLISH ENGLISH CHRONOGRAPH MODELS • Review all chronographs to determine your watch type This chronograph watch has three functions: STOPWATCH HOUR HAND PUSHER “B” PUSHER “A” AB C SMALL SECOND HAND CROWN POSITION PUSHER “C” STOPWATCH 1/20 SEC.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH CHRONOGRAPH • • • • The Chronograph is capable of measuring: Minutes elapsed up to 1 hour (12 o’clock eye) Hour elapsed up to 12 hours (9 o’clock eye) Seconds elapsed up to 1 minute (seconds sweep hand) BEFORE USING THE CHRONOGRAPH: Adjust all the chronograph hands to the “0” or 12 hr. position. 9:19 AM Page 24 ENGLISH NOTE: PRESSING and HOLDING either pusher “A” or “B” will cause the hands to move continually until the pusher is released.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM ENGLISH ENGLISH CHRONOGRAPH MODELS SETTING THE DATE TYPE 2 CHRONOGRAPH SECOND PUSHER “A” CHRONOGRAPH MINUTE MINUTE HAND CHRONOGRAPH HOUR 7 B C CROWN POSITION NORMAL POSITION “A” PUSHER “B” HOUR SMALL SECOND DATE SETTING THE TIME 1) PULL the crown out to the 2nd position “C”. 2) Turn the crown to set hour and minute hands. 3) When the crown is pushed back to the normal position “A”, small second hand begins to run.
W223_Analog2_NA_EN.qxd 6/5/09 minute hand, and chronograph hour hand return to zero position. TIME MEASUREMENT Page 28 ENGLISH ENGLISH RESET 9:19 AM STOP *Do not push crown to normal position while the chronograph second hand returns to zero position. It stops on the way when crown is returned to normal position and its position is recognized as zero position. CHRONOGRAPH RESET (INCL.
W223_Analog2_NA_EN.qxd 6/5/09 TIME TO SET THE TIME: TYPE 3 MINUTE PUSHER “A” CHRONOGRAPH MINUTE CHRONOGRAPH 1/20 SECOND CROWN POSITION 你 D A HOUR CHRONOGRAPH SECOND B C PUSHER “B” DATE SECOND BASIC OPERATIONS • • Page 30 ENGLISH ENGLISH • • 9:19 AM 6 o’clock eye shows seconds. 10 o’clock eye shows “minutes elapsed” for chronograph. 2 o’clock eye shows “1/20 seconds elapsed” for chronograph. Chronograph second hand shows “seconds elapsed” for chronograph. 1.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH CHRONOGRAPH THE CHRONOGRAPH IS CAPABLE OF MEASURING: • • • 1/20 seconds elapsed up to 1 second (2 o’clock eye). Seconds elapsed up to 1 minute (chronograph second hand). Minutes elapsed up to 30 minutes (10 o’clock eye). NOTE: Chronograph will operate continuously for 4 hours, after which it will automatically stop and reset.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH STANDARD CHRONOGRAPH MEASUREMENT: 1. PRESS pusher “A” to start timing. 2. PRESS pusher “A” to stop timing. 3. PRESS pusher “B” to reset. SPLIT TIME MEASUREMENT: 1. 2. 3. 4. 5. PRESS PRESS PRESS PRESS PRESS pusher “A” to start timing. pusher “B” to split. pusher “B” to resume timing. pusher “A” to stop timing. pusher “B” to reset. INDIGLO® NIGHT-LIGHT With the crown in the “A” position, PUSH crown to the “D” position. Entire dial will be illuminated.
W223_Analog2_NA_EN.
W223_Analog2_NA_EN.
6/5/09 ENGLISH TO MEASURE THE TIME REMAINING: Set the triangle to the hour or minute position when you wish to complete the activity, and check the watch periodically for progress towards that goal. In the illustration shown on the previous page on the right you can stop when the minute hand reaches the 20 minutes past the hour position.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH 3) In the A.M., rotate the ring until the “S” (south) marker is halfway between the hour hand and 12:00 (after the hour hand or within the shortest distance between the hour hand and 12:00). 4) In the P.M., rotate the ring until “S” is before the hour hand and halfway between the hour hand and 12:00. How to Adjust Bracelet (Variations of the following bracelet sections apply to all watch models). SLIDING CLASP BRACELET 1 Open locking plate. 2.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 44 ENGLISH ENGLISH BRACELET LINK REMOVAL BATTERY REMOVING LINKS: Timex strongly recommends that a retailer or jeweler replace battery. If applicable, push reset button when replacing battery. Battery type is indicated on caseback. Battery life estimates are based on certain assumptions regarding usage; battery life may vary depending on actual usage. 1. Place bracelet upright and insert pointed tool in opening of link. 2.
W223_Analog2_NA_EN.qxd 6/5/09 ENGLISH TIMEX INTERNATIONAL WARRANTY Your TIMEX® watch is warranted against manufacturing defects by Timex Group USA, Inc. for a period of ONE YEAR from the original purchase date. Timex and its worldwide affiliates will honor this International Warranty. Please note that Timex may, at its option, repair your watch by installing new or thoroughly reconditioned and inspected components or replace it with an identical or similar model.
W223_Analog2_NA_EN.qxd 6/5/09 9:19 AM Page 48 ENGLISH Mexico and Central America 01 800 01 06000 (U.S.); Portugal +351 212 555 460; UK, Middle East and Africa +44 20 8687 9620 For other areas, please contact your local Timex retailer or Timex distributor for warranty information. In Canada, the U.S. and in certain other locations, participating Timex retailers can provide you with a postage-paid, preaddressed Watch Repair Mailer for your convenience in obtaining factory service.