TSA3118B Audio Amplifier User Guide Tinysine Electronics @ 2017 Version 1.
www.tinysine.com INTRODUCTION TSA3118B is a 2x50W audio amplifier board with a new Audio plus Bluetooth module that supports Apt-X. It has perfect class-D architecture(Based on TPA3116D2) and each channel has 50W power output. Both of channels are capable of outputting nominal power simultaneously and continuously. This board can be powered by any DC10V-24V power supply. It can be used to drive any 4Ω or 8Ω passive speakers. Features: Dimensions: 6.9cm x 10.3cm x 2.5cm Bluetooth 4.
www.tinysine.
www.tinysine.com Step by step 1.
www.tinysine.com 2. Open the 2 screw terminals on the amplifier's output. After place the total copper wires into the screw terminals. Be aware that connecting the + and - with the corresponding screw terminals. Then close the screw terminals by turning in the opposite direction. 3. If you want to use line-in audio source, you can connect it to TSA3118B’s line in. If not, just ship this step. 4. Power the amplifier with your DC power supply, you will hear the amplifier teeth immediately.
www.tinysine.com 5. Turn on Bluetooth on the device you want to connect to the amplifier. Find TSA3118B on your Bluetooth list and connect to it. The amplifier comes with a distinct beep sound when a connection is established. Now you can play your music. Note: TSA3118B can auto detect the Aux in/Line in Audio input. Bluetooth Audio source has higher priority. When Bluetooth audio is paused or bluetooth is disconnected. The amplifier will output the TV audio.
www.tinysine.
FCC Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
requirement, only if the test result comply with FCC part 15.247 and 15.209 requirement, then the host can be sold legally. End Product Labeling This transmitter module is authorized for use portable and mobile exposure. The final end product must be labeled in a visible area with the following: Contains FCC ID: 2ARMD-TSA3118B.
● The transmitter module may not be co-located with any other transmitter or antenna. Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: ● Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne.
L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce module. Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme indiqué dans ce manuel.