User manual

12 MODBUS Master
English
2.2 Add an energy counter by LAN communication (TCP)
The following procedure describes how to add a new energy counter combined to a LAN GATEWAY module
using LAN communication (TCP).
Add an energy counter by clicking on button.
After that, in the left column EnergyCounter1 will be shown under Instruments item (Pict. 5).
Pict. 5 – Adding an energy counter by LAN communication
In this window, three tabs are available: Connection Parameters, Device Setup, Measure.
In Connection Parameters page, the first displayed tab, select Modbus TCP in Modbus Mode field and then
enter the correct IP Address of the connected LAN GATEWAY module. The TCP Port is always fixed to 502.
Confirm the parameters with Apply key.