Manual

Power tube and valve removal.

NOTE: Do not remove the gas line fitting unless it is leaking

or you need to replace the valve. If you should do so you will

need some teflon tape or paste to reinstall it.

Field Stripping / Receiver Disassembly (continued from page 11)

First, you need to complete Marker / Receiver Disassembly

Instructions on page 11.

To release the power tube and valve, unscrew the two valve

lock bolts on the outer right-side receiver.

Valve removal from power tube: If it is necessary to remove

the valve, use a wrench to slowly unscrew the gas line fitting.

Once the fitting is out, the valve will slide out the back of the

power tube.

NOTE: Check the external valve o-ring at this time. If the

o-ring is damaged your marker will not function correctly.

Reinstalling valve: Insert valve into power tube, align holes

and add teflon tape or paste to gas line fitting threads,

slowly screw into valve and snug with wrench.

Reinstalling: Apply red loctite to bolts threads when

reinstalling. Do not over tighten valve lock bolts when

reinstalling.

Valve Lock Bolts