Installation Instructions

Startup

Installation of the VoIP module

Tools required

• Small/medium slotted screwdriver for tiptel.com 410, 810, 411 and 811

Installation sequence

Observe the following sequence when

installing the VoIP module:

•

Turn off the system (disconnect power

cord)

• Open the housing:

Insert a slotted screwdriver (4 mm)

or similar from below at the positions

shown right (1) into the grooves in the

top of the housing until it can go no

further. Pull the screwdriver towards

you (2) to disengage the snap-in fixing

device; lift the cover back.

• Installation of the VoIP module

• Locate the slot for installation.

• Install the VoIP module as shown

(component side up).

• You can use one of the two slots;

the other one is for the VCM

module.

•

Close the housing.

• Connect the system to the mains and the local network.

LEDs