Quick Start Guide

Quick Installation Guide
19
Notes for network admins
The telephone system comprises a DHCP client and a DHCP server. When booting
the telephone system tries to obtain an IP address from a DHCP server in the net-
work. If this is successful the telephone system's web configuration can be accessed
under the assigned IP address. In case there is no DHCP server available or the tele-
phone system could not obtain an IP address due to other reasons the following fac-
tory default settings will be active:
IP address of the: 192.168.34.100
telephone system
Subnet mask: 255.255.255.0
User name/password: admin/admin
DHCP server: active
Address range: 192.168.34.10 to 192.168.34.29
To adapt these data to your network please connect a caller ID telephone to the tele-
phone system. Please dial for:
-Display IP address  and hang up
(Display is made via Displayinfo and call back)
- Write IP address PINxxxxxxxxxxxx
(you will hear a positive prompt "Tataa")
-Display subnet mask
 and hang up
(Display is made via Displayinfo and call back)
- Write subnet mask
PINxxxxxxxxxxxx
(you will hear a positive prompt "Tataa")
Factory default PIN: "0000".
If you modify the IP address via key code at your telephone, the telephone system
can be accessed under that IP address after a short while. The DHCP client then was
deactivated and the chosen IP address was saved as static IP address.
The DHCP server is still active but was adjusted to the address range of the chosen
IP address. In case you do not wish to use the DHCP server or such a server is al-
ready active in your network, you can deactivate the telephone system's DHCP server
in the web configuration under "Network - Settings - DHCP Server".