Operation Manual

MyPBX Standard User Manual
www.yeastar.com Page 86
·Trunk Name
Choose the trunk with callback rules
·Strip digits from front
Define how many digits will be stripped from the call in number before the
callback is placed. For example, when you call from number 123456789 into
MyPBX, the caller ID is 0123456789, but you can only call 123456789
successfully from MyPBX trunk. You should configure number 0123456789 as
the call back number and strip 1 digit before the callback is placed
·Prepend before dialing
Define digits added before a callback number before the callback is placed. For
example, the call in number (Caller ID) is 123456789, MyPBX need to send
9123456789 to its trunk when call to this number. You should configure
123456789 as the call back number and add 9 before the callback is placed. You
can add „w‟ for analog trunks for some delay too.
Figure 3.5.13.3
3.5.14 Speed Dial Settings
1) Options
·The prefix of speed dial
The prefix should be dialed before the speed dial number. Default is *99.
2) Add new speed dial.
·Source Number
The speed dial number.
·Destination Number
The number you want to call.
e.g. The source number is ”123”. The destination number is 5503305.The prefix
number is *99.You can use an extension with any type to dial *99123, then it
will call to number 5503305.
Note: Don‟t forget to add the outbound dial prefix if you would like to dial the
speed dial number through trunk.