TM ZEUS Series: microZEUS Power Supply
Zeus Series: microZEUS with Flying Bus Boards The uZEUS is a 4HP power supply module for Eurorack format synthesizers. This version features four standard spade terminals to connect to rigid bus boards like the ZEUS Passive Bus Boards. Connection diagram is provided at the end of this manual. Provided with the module is a 1000mA +15VDC unregulated wall adapter with a 2.5mm positive center pin connector.
Zeus Series: microZEUS with Flying Bus Boards Wall Adapter Information: TM The Triad Magnetic wall adapter supplied with the uZEUS can deliver current in TM excess of 1000mA. The Ault wall adapter supplied with the Happy Ending kit is rated 1000mA and it is strongly recommended that it be kept at that limit. Please be sure to check the temperature of your wall adapter about 20 minutes after power up. Make sure to do that each time you add more modules to your system.
Zeus Series: microZEUS with Flying Bus Boards Using the –12V Rail: The –12V rail uses a switching regulator. This switching regulator needs to have a minimum load of 100mA (out of 500mA) at any given time. The uZEUS has a factory setting to self consume this current. If your uZEUS is powering more than four (4) analog modules you can then disable this setting if desired to make this 100mA available for use by your modules.
Zeus Series: microZEUS with Flying Bus Boards The uZEUS terminals GROUND (GND) +12V -12V VR *VR is used with Tiptop Audio ZEUS Passive Bus Board. VR Should be left open if connected to other bus boards.
Zeus Series: microZEUS with Flying Bus Boards Connecting the uZEUS to the ZEUS Passive Bus Board 12V 12V 12V +5V +5V +5V +12V +12V +12V 12V VR +12V GND GND 12V GND GND GATE CV +5V +12V GATE CV +5V +12V GATE CV +5V +12V GATE CV +5V +12V GATE CV +5V +12V GND GND GND GND GND 12V 12V 12V 12V 12V GATE CV +5V +12V C VR A G B +12V GND 12V 12V +5V +5V +12V +12V GND +5V +12V 12V GND GATE CV +5V +12V GATE CV +5V +12V GND GND GND 12V 12V 12V GATE CV +5V +12V GATE CV
