User manual

TIREMONI TM-2X0 TYRE PRESSURE MONITORING SYSTEM
14 23.05.2017 TIREMONI USER MANUAL V2.1
Installation of tyre pressure sensors
As each sensor has its own position market by sensor number, you have to make sure it is installed in
that pre-set position. There could be a different number of tyres depending on your model. When
inserting batteries in every sensor please don’t mix up sensor caps.
Sensor identification tables (pls also refer to www.tiremoni.com/FAQ.html) will show where each sensor
number should be located. This example is showing a 10 wheel tractor with a 12 wheel trailer:
Your actual configuration may differ; (different number of sensors).
In the example the system consists of 3 relais: one for the tractor and one each for trailer #1 and
trailer #2. Sensor positions are marked on the sensor cap and inside on the sensor label.
Note:
Make sure battery polarity is correct when inserting it.
Make sure sensor body won’t mix up with other sensor cap.
When batteries are exhausted soon, the battery level will be displayed on the LCD monitor.
The tractor unit (relais) can monitor
up to 10 wheels as shown
here on the right side.
The first trailer unit (relais) can
display up to 12 wheels as shown
here on the right side.
The second and third trailer unit
(relais) can display up to 12 wheels
as shown here on the right and are
displayed on the second screen.