User manual

TIREMONI TM-2X0 TYRE PRESSURE MONITORING SYSTEM
TIREMONI USER MANUAL V2.1 23.05.2017 15
Insert Batteries in Sensors
A. Remove sensor cap
B. Insert lithium battery and make sure battery polarity is correct when inserting it.
Right now, monitor will receive signals from corresponding sensors and report pressure value on
the screen. At first, you will find that the value shows “00.0”. This is because sensors have not
been mounted yet. The screen could show as below:
In this example A1 (front left) has just been installed
Note:
After removing battery, wait a minimum of 10 seconds before re-inserting battery again. This is
required for correctly resetting the sensor.