User manual

TIREMONI TM-2X0 TYRE PRESSURE MONITORING SYSTEM
TIREMONI USER MANUAL V2.1 23.05.2017 29
Note:
After selecting vehicle type, please reset the relay, so that the new data are stored on both sides.
Otherwise the monitor will continue to display the previous vehicle type. Please also consult
chapter 4 – ADD NEW RELAY.
This chart shows available vehicle types fort ruck and trailer.
The sensor – wheel position assignment works according to the following schematic:
Starting in front left wheel position with No. 1, continue to the right with No. 2, then 3, and 4 (when
used).
Continuing with the next axle in the left position with No. 3 (or 5 if you have 4 sensors on the 1st
axle) and continue to the right with ascending numbers.
Each relay can receive data from up to 12 sensors on 3 axles.