User's Manual

14
Ribbon Encoder
Error
Disconnected ribbon,
Ribbon end or
encoder error occurs.
17
IC Module Up/
Down Error
Repair service is required.
IC Content module
position error occurs.
50
[Changer] Module
Response Timeout
Turn off → Remove any cards →
Reboot
Changer
communication error
occurs.
51
[Changer] Module
Transmission
Timeout
Turn off → Remove any cards →
Reboot
Changer
communication error
occurs
52
[Changer] Home
Position Failure
Turn off → Remove any cards →
Reboot
An error occurs at
the Changer home
position.
53
[Changer] Card
Flipper Failure
An error occurs at
the Changer turn up.
54
[Changer] Card
Input Timeout
The printer stops when
the card is entering the
Changer.
55
[Changer] Card
Input Jam
The card fails to enter
the Changer on time.
56
[Changer] Card
Output Jam
A card is jammed in the
Changer.
57
[Changer] Card
Exist
An abnormal card is
found in the Changer.
15
Media Error Check the card (media) and
path sensor status.
The media error
occurs.
16 EEPROM Error Reboot or replace the EEPR0M.
An EEPR0M read/
write error occurs.
③ Ribbon
④ Card
⑤ Miscellaneous
Check the Ribbon and Ribbon
encoder status.
74
-Warning
①Card
23 [IC] Contact Error Check the IC contact module.
IC fails to make
contact.
24
[MS] Encoder
Error
Check the MS module.
An MS encoding
error occurs.
25 [MS] Read Error
All 3 MS tracks fail to
read.
Check the MS module.
26
[MS] Read STX
Error
No STX is found in the
MS reading.
Check the MS feeding.
27
[MS] Read Parity
Error
A parity error occurs
in the MS reading.
Check the MS feeding
28
[MS] Read ETX
Error
Check the MS feeding.
29
[MS] Read LRC
Error
Check the MS feeding and
replace the MS card.
30
IC Module
Response Timeout
IC module
communication fails.
Check the IFM B/D.
31 RF Module
Response Timeout
RF module
communication fails.
Check the IFM B/D.
33 Card Eject Error
Changer module
communication fails.
Check the Flipper and Flipper
B/D.
34
Card Input
Timeout
The card input is
interrupted.
Check the Input Hopper and for
any jammed cards.
LRC is inconsistent in the
MS reading.
35
Ribbon Life Low
Prepare to replace the ribbon.
The ribbon life is reduced
to 10% or less.
② Ribbon
36
No Ribbon Life
Replace the ribbon with a new
one.
The ribbon is fully
consumed.
38
RF Tag Ribbon
Error
Check the ribbon and tag
authentication.
The ribbon is not
installed properly.
32
SAM Module
Response Timeout
Check the SAM B/D interface
and SAM B/D.
③ SAM
SAM module
communication fails.
No ETX is found in the
MS reading.
75
Code Code Name Description Solution
Code Code Name Description Solution
Code Code Name Description Solution
Code Code Name Description Solution
Code Code Name Description Solution
Code Code Name Description Solution
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Turn off → Remove any cards →
Reboot
Install printer and ready POINTMAN User Guide Manual