User's Manual

⑦ About
This tab displays the version information.
1. Hold down both the “EJECT” and “RIBBON SET” buttons until “USER MODE”
is indicated in the LCD display.
3. When “USER MODE” is indicated in the LCD display, press the
“RIBBON SET” button to go into “3. SET MODE”. Then, hold down
the “RIBBON SET” button.
Go up the menu: Press the “EJECT” button.
Go down the menu: Press the “RIBBON SET”
button.
Check
4. When “SET MODE” is indicated in the LCD display, press the “RIBBON
SET” button several times to go to “4. NETWORK CONFIG”. Then, hold
down the “RIBBON SET” button until the IP address displays on the screen.
SET MODE
STAND-BY MODE USER MODE
NETWORK CONFIG IP/SUB/GATEWAY
-Check IP Address
Check IP Address & Print Test Card
58 59
2. When “USER MODE” is indicated in the LCD display, hold “RIBBON
SET” button.
USER MODE
Install printer and ready POINTMAN User Guide Manual