Use and Care Manual

PRELIMINARY CHECKS

Connect the legrest unit with the Coupling Shaft,fit the DK Circlip to the end

of the shaft and lock it(check the illustration below)

Raise the Legrest unit,thread the Air Hoses into the Air Nozzle,and fit the Air

Valve plug into the Air Valve Port which located at the face side of seat base,

make sure they are well secured.check the illustration below)

DK Circlip

Air Hose

Air Nozzle

Air Valve Port

Air Valve Plug

Coupling Shaft

PRELIMINARY CHECKS

Step 4:Install the controller unit

Take the controller unit out of the accessories box;

Connect the data line of the controller to the port to the lower inner side of the right

armrest(pay attention to the convex and concave of the connector and port),then

tighten the screw cap clockwise.(Check the illustration below for reference)

Port For Controller Data Line

Screw Cap

Connector Of Controller Data Line