Use and Care Manual

PRELIMINARY CHECKS
22
Move Method
Roll the chair on its casters to the desired location.
Incline the backrest to upright position.
Turn off the power switch and unplug the appliance from the electrical outlet.
Using two people,push down on the backrest and lift up on the front side by grabbing
the moving holder located to the front bottom of the armrest,roll the chair on its
casters to the desired location(check the sketch for reference)
CAUTION
CAUTION
Do not move the chair when there is user inside.
To carry this product, do not lift by the footrest or armrest,hold the chassis and
steady the backrest(have 4 or more people to carry the product).
Connect this appliance to a 3-wire properly grounded outlet.
Turn on the main power switch located to the lower back of
the right armrest.
Connect To Power
Please verify that there is no damage to the supply cord before plug in.
Please verify that the main power switch is turned off before connecting to power.
PRELIMINARY CHECKS
21
Connect the power cable to the product power socket located at the power box
of the product.(Check below illustration for reference)
Switch ON the power by the lower outer side of the right armrest,raise the backrest
of the product to fully upright position.
After the installation of all accessories,plug the power cord into a well grounded
three cord socket, switch on the power, use the controller to start the operation
（check above illustraion ）.
Step 5:Other Accessories
Power Cord
Power Switch
Fuse
Power Socket