Use and Care Manual

! WARNING
Improper gasket installation will result in condensation
USER GUIDE
www.titan-appliances.com
13
Attentions:
Titan Products recommends allowing the unit to run overnight before loading with product. As warm air
rises, the temperature inside the unit tends to be slightly warmer at the top and slightly cooler at the
bottom.
When plugged in, the unit will begin operating under the factory default settings. If the unit was
turned off during installation, simply press and the unit will immediately switch on. To turn the unit off,
press again.
Handle Installation
Step 1 - Open the door and carefully pull the door gasket around the area where the handle is to be installed.
Step 2 - Insert each Phillips head screw through the gasket side of the door until the screw passes through the
door.
Step 3 - Align the handle with the screws and tighten the screws using a Phillips head screwdriver until the handle
is flush against the door frame.
Caution: Do not overtighten the screws as this may cause damage to the handle or to the stainless steel
door.
Step 4 - Carefully press the door gasket into its original position.
Gasket
Screw
Flat Washer
Locked Washer
Handle
Door Frame