Installation Guide

ManualsBrandsTitan ManualsLumber & CompositesBlank Post Assembly for 36 in. High Railing

LEVEL RAIL

INSTRUCTIONS

RAILING DYNAMICS, INC.

FOR HOME, FOR LIFE™

135 STEELMANVILLE ROAD

EGG HARBOR TOWNSHIP, NJ 08234

TEL: (877) 420-7245

FAX: (866) 277-5160

E-MAIL: CS@RDIRAIL.COM

URL: WWW.RDIRAIL.COM

NOTE: Check with your local building code ofce for design load requirements for

guard rails and bottom space requirements. All supporting structures should be built

in accordance with applicable building codes.

Summary of content (4 pages)

PAGE 1
LEVEL RAIL INSTRUCTIONS NOTE: Check with your local building code office for design load requirements for guard rails and bottom space requirements. All supporting structures should be built in accordance with applicable building codes. RAILING DYNAMICS, INC. FOR HOME, FOR LIFE™ 135 STEELMANVILLE ROAD EGG HARBOR TOWNSHIP, NJ 08234 TEL: (877) 420-7245 FAX: (866) 277-5160 E-MAIL: CS@RDIRAIL.COM URL: WWW.RDIRAIL.
PAGE 2
1. 2. Determine desired rail placement and snap a line to ensure all posts are aligned properly (Fig. 1). Make sure sufficient mounting structure exists in areas to receive posts. On wood framed installations, install blocking where necessary. Secure all posts in place and check for plum (Figs. 2, 3, 4, 5). Tip: Post flanges are drilled to accept four 3/8" diameter fasteners. Use the appropriate type of fastener for your installation to insure post attachment meets the required loads.
PAGE 3
. 4. 5. Locate and mark the center point on the underside (unrouted side) of the bottom rail. Attach the rail support to the bottom rail as shown below (Fig. 11) using the supplied hardware. Lay the bottom lineal on a clean, nonabrasive surface (Fig. 12). Orienting the tabs (Fig. 13) to engage the aluminum stiffeners, insert a crimped baluster into the second routed hole from each end. Distribute the remaining crimped balusters evenly throughout the section. Then connect the top lineal (Fig. 14).
PAGE 4
6. Install the bracket covers as shown in Figures 18 and 19. Install the 2 piece trim ring shown in Figure 20. Then glue post cap in place (Fig. 21). (Fig. 18) (Fig. 19) Attach the rail support to the deck surface and snap the cover in place (Fig. 22). (Fig. 21) (Fig. 22) (Fig. 20) TMPLI 12.