WINE STORAGE USER GUIDE & SERVICE MANUAL CLEANING, MAINTENANCE, AND MORE TT-W2446PDZ 24" Dual Zone Panel Ready Single Door Wine Cooler
USER GUIDE & SERVICE MANUAL www.titan-appliances.
USER GUIDE www.titan-appliances.com Welcome To Titan Appliances Congratulations on purchasing your Titan appliance! We at Titan offer quality products that compliment your lifestyle. To learn more about our products please visit our website at www.titan-appliances.com. This manual contains information on how to install, use and maintain your appliance to perform at its peak efficiency. To safely transport your appliance in the future, please save the original product packaging.
USER GUIDE www.titan-appliances.com SAFETY AND WARNING Instructions Before Using Your Appliance. Before use, make sure all packaging labels and materials are removed from the unit. Be sure to keep track of all included parts and pieces before discarding packaging materials. It is advised that you keep the original box and packaging materials in case you are ever to move or ship the appliance in the future. Clean the interior surface with a clean soft cloth.
USER GUIDE www.titan-appliances.com ! DANGER ! WARNING Service must be done by factory authorized Danger means that failure to follow this safety service personnel. Any parts shall be replaced statement will result in severe personal injury with like components. Failure to comply could or death. increase the risk of possible ignition due to ! WARNING incorrect parts or improper service.
USER GUIDE www.titan-appliances.com VACATION REQUIREMENTS INSTALLATION ! WARNING Environmental Requirements • Short vacations: Leave the appliance operating during This model is intended for indoor/interior applications only vacations for less than three weeks. and is not to be used in installations that are open/ • Long vacations: If the appliance will not be used for exposed to natural elements. several months, remove all items and turn off the appliance. Clean and dry the interior thoroughly.
USER GUIDE www.titan-appliances.com Electrical ! WARNING SHOCK HAZARD — Electrical Grounding Required. Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected. Never remove the round grounding prong from the plug and never use a two-prong grounding adapter. Altering, cutting or removing power cord, removing power plug, or direct wiring can cause serious injury, fire, loss of property and/or life, and will void the warranty.
USER GUIDE www.titan-appliances.com Cutout Dimensions PREPARE SITE Your Titan product has been designed for either freestanding or built-in installation. When built-in, your unit does not require additional air space for top, sides, or rear. However, the front grille must NOT be obstructed, and clearance is required for an electrical connection in the rear. ! CAUTION Unit can NOT be installed behind a closed cabinet door.
USER GUIDE www.titan-appliances.com Installation Clearance Requirements When installing the cooler under a counter, follow the recommended spacing dimensions shown. ⚫ To ensure proper service access and ventilation, allow at least 2-3” of clearance at the back as shown in the diagram. ⚫ The installation should allow the unit to be pulled forward for servicing, if necessary. ⚫ The power cable is located on the back right of the unit and has a length of 72” to accommodate multiple outlet locations.
USER GUIDE www.titan-appliances.
USER GUIDE www.titan-appliances.com Product Specification DESCRIPTION OF PRODUCT Dual Zone Panel Ready Wine Cooler MODEL TT-W2446PDZ VOLTAGE / FREQUENCY AC 115 / 60 Hz AMPERAGE 1.
USER GUIDE www.titan-appliances.
USER GUIDE www.titan-appliances.com Dimensions Note: Cabinet depth provided includes a 3/4” overlay panel. Note: A screw is present on the top hinge of the unit, adding an additional 1/8” to the height of the cooler. If installing cooler flush with cabinet fronts, additional clearance may be needed. Note: Handle dimensions listed are for the optional Titan handle, sold separately. Please contact service@titan-appliances.com to inquire and purchase. Note: No handle is included with the unit.
USER GUIDE www.titan-appliances.com Dimensions 15” 1- 1/8” 7-5/16” 1- 1/2” Panel-ready Door 5-1/4” 19- 1/4” (Optional Titan Handle screw holes) 2-3/16” 15” 4-1/4” ” 16 3/ 29-3/4” - 29-13/16 ” 23-1/2” Overlay Panel Panel Thickness: 5/8” - 3/4” 2-5/8” - 5” 2-5/8” - 5” Note: Compatible with framed overlay panels only.
USER GUIDE www.titan-appliances.com General Installation Before installation, please check and ensure that: 1. The appliance should be installed in accordance with local electrical code requirements. 2. The appliance should be placed in a location that is strong enough to support its total weight –always assume the weight when the appliance is fully loaded. 3.
USER GUIDE www.titan-appliances.com Types of Installation: This appliance can be installed as a free standing or built-in unit. Keep in mind adequate ventilation and access for service is a must. 1. For free-standing installation: • Allows the installation of the appliance in almost any place you desire. • Please follow the stated instructions for electrical requirements, and leveling of the appliance. 2.
USER GUIDE www.titan-appliances.com Installing the Overlay Panel To install the overlay panel onto the door, please follow the instructions below. Refer to the dimensions page to ensure proper measurements prior to installation. 1. Open the door. 2. Temporarily remove the door gasket to see the 10 holes for the overlay panel. There are 2 holes on the top and bottom sides of the door with either 3 or 5 holes on the left and right side depending on where the handle is located.
USER GUIDE www.titan-appliances.com Attention: Titan Products recommends allowing the unit to run overnight before loading with product. As warm air rises, the temperature inside the unit tends to be slightly warmer at the top and slightly cooler at the bottom. When plugged in, the unit will begin operating under the factory default settings. If the unit was turned off during installation, simply press and hold Power and the unit will immediately switch on. To turn the unit off, press Power again.
USER GUIDE www.titan-appliances.com Wine Shelf Removal 1. Open the door completely. 2. Remove all of the contents loaded on the shelf, if applicable. 3. Line up the shelf notches with the rail posts as indicated below. This will require you to hold on to both rails as you move the shelf to line up the posts with the notches on both sides of the shelf. 4. Evenly lift the shelf up and then pull the shelf out.
USER GUIDE www.titan-appliances.com Reversing the Door Swing of Your Appliance 1 1 1. 2 Remove the 2 screws from the lower door axis (1) and remove a top screw(4) on top of the hinge . Then remove the door (2) and remove the axis plate (1) from the door. 2 4 3 2. Remove the 3 screws from the top right hinge (3) and remove the top right hinge. Note: Compatible with framed overlay panels only.
USER GUIDE www.titan-appliances.com Reversing the Door Swing of Your Appliance 3 7 3. Unscrew 2 screws and remove the door switch cover (5). Unscrew 2 screws and remove the door stopper (6). Remove 2 screws from the right upper hinge connecting plate (7) mounted on top of the door and remove it. Rotate the door 180 degrees upside down. Take out the new left upper hinge connecting plate and door stopper from the hardware package and install them with 2 screws. 6 5 4 4.
USER GUIDE www.titan-appliances.
USER GUIDE www.titan-appliances.com Power Press and hold this button for three seconds to power your unit on. Once pressed, the "Run" indicator light will illuminate to indicate the unit is on and running. Press and hold this button for three seconds again and the unit will power off and the "Run" indicator light will turn off. + Button Press this button to increase the setting temperature by one (1) degree increments.
USER GUIDE www.titan-appliances.com Energy Saving (Sabbath Mode) Energy Saving mode disables system responses to user-initiated activities and all external functions, including lighting, display and audible alarms. The unit will maintain internal temperatures and set points. To enable or disable this mode, press the Energy Saving button . The interior light and control display will go dark until the user disables Energy Saving mode.
USER GUIDE www.titan-appliances.com ! WARNING Allow at least 24 hours for your wine cooler to run before storing your beverages to allow the temperature to acclimate. Whether your wine cooler can reach the actual set temperature depends on the ambient environmental condition ! CAUTION 1. If you powered the unit off, please wait at least five (5) minutes before powering it back on. 2. The ambient environmental conditions determine whether your unit can reach the actual set temperature. 3.
USER GUIDE www.titan-appliances.com Sounds Defrosting Some sounds and noises generated by this appliance The unit automatically defrosts under most ambient may not be common to you, however most of these conditions and refrigerating settings. However some sounds are normal. Hard surfaces like floor and walls frost may build up under colder settings. may make the sounds seem louder than they actually Additionally, frost may also build up under more are. humid ambient conditions.
USER GUIDE www.titan-appliances.com Maintenance Cleaning Exterior Cleaning Vinyl Clad (Black) Clean surfaces with a mild detergent and warm water If any surface discoloring or rusting appears, clean it solution. Do not use solvent-based or abrasive quickly with Bon-Ami® or Barkeepers Friend cleaners. Use a soft sponge and rinse with clean water. Cleanser® and a nonabrasive cloth. Always clean with Wipe with a soft, clean towel to prevent water the grain.
USER GUIDE www.titan-appliances.com ! Warning DO NOT use an ice pick or other sharp instrument to help speed up defrosting. These instruments can puncture the inner lining or damage the cooling unit. DO NOT use any type of heater to defrost. Using a heater to speed up defrosting can cause personal injury and damage to the inner lining. NOTICE The draining pan was not designed to capture the water created when manually defrosting.
USER GUIDE www.titan-appliances.com Troubleshooting PROBLEM POSSIBLE CAUSE • Not plugged in. Appliance does not operate • The appliance is turned off. • Tripped circuit breaker or blown fuse. • Check the temperature control setting. • External environment may require a higher setting. Appliance is not cold enough • The door is opened too often. • The door is not closed completely. • The door gasket does not seal properly. • The room temperature is higher than normal.
USER GUIDE www.titan-appliances.com Titan Products, LLC Limited Warranty THIS WARRANTY COVERS: • The original purchaser within all states in the continental United States (excluding Hawaii and Alaska) for one year from the date of purchase against defects in materials and workmanship under normal use and service. • Titan will be responsible for all transportation costs incurred in the event that service under this warranty is needed for the first 3 months from original purchase date.
