Use and Care Manual

Types of Installation:

This appliance can be installed as a free standing or built-in unit. Keep in mind adequate ventilation and access

for service is a must.

1. For free-standing installation:

• Allows the installation of the appliance in almost any place you desire.

• Please follow the stated instructions for electrical requirements, and leveling of the appliance.

2. For built-in installation:

• Allows the installation of the appliance under a counter or in a kitchen cabinet. Please ensure that the

required clearance space for the appliance is provided.

• Please make sure to allow adequate ventilation space.

• Place the appliance in front of the installation location. Adjust the feet and place the unit flat on the floor

or on a platform depending on your installation requirements.

• If the electrical outlet for the appliance is behind the cabinet, plug in the appliance.

• Push the appliance into position.

• Do NOT install the unit behind a closed cabinet door.

Unit Installation Steps

1. P

lug in the p

ower/electrical cord.

2. Gently push the unit into position. Be careful not to entangle the cord.

3. Re-check the leveling, from front to back

and side to side. Make any necess

ary adjustments. The unit’s top

surface should

be approximately 1/5"below the countertop.

4. Remove the interior packing material and wipe out the inside of the unit with a clean, water-dampened cloth.

5. To prevent damaging the door or door gasket, make sure the door is open at least 90-degrees when pulling

shelves out of the rail compartment.

6. The door opens to a maximum of 135 degrees with a door stop on the bottom hinge preventing the door from

opening further.

USER GUIDE