Use and Care Manual

USER GUIDE
www.titan-appliances.com
15
Installing the Overlay Panel
To install the overlay panel onto the door, please follow the instructions below. Refer to the dimensions
page to ensure proper measurements prior to installation.
1. Open the door.
2. Temporarily remove the door gasket to see the 10 holes for the overlay panel. There are 2 holes on the top
and bottom sides of the door with either 3 or 5 holes on the left and right side depending on where the handle is
located. The handle side will have 5 holes.
3. Open the hardware package containing 10 self-tapping screws (ST4*30 size) for the overlay panel.
4. Clamp the overlay panel to the door firmly with bar clamps and screw the self-tapping screws into the
overlay panel. Perform this step for each screw until the overlay panel is completely secured.
5. Reattach the door gasket and close the door.
Note: If handles will be installed, thread 2 screws and washers in the accessory bag onto the overlay
panel and refer to Handle Installation Instructions.