Use and Care Manual

USER GUIDE
www.titan-appliances.com
16
! WARNING
Improper gasket installation will
result in condensation
Attention:
Titan Products recommends allowing the unit to run overnight before loading with product. As warm air
rises, the temperature inside the unit tends to be slightly warmer at the top and slightly cooler at the
bottom.
When plugged in, the unit will begin operating under the factory default settings. If the unit was turned off during
installation, simply press and hold Power and the unit will immediately switch on. To turn the unit off, press
Power again.
Handle Installation
1. Confirm if the overlay panel has already been installed onto the unit. If not, refer to Overlay Panel Installation
to mount the overlay panel onto the unit.
2. Push aside the door gasket. Under the gasket you will see two designated holes for handle installation. Mark
handle hole locations on the overlay panel.
3. Remove overlay panel from door. Using 3/16” drill bit, create holes for handle screws.
4. Re-install overlay panel on the door.
5. Install the handle tightly as shown with two 1-1/2” machine screws.
Handle
Door Frame
Gasket
Flat Washer
Locked Washer
Screw
Note: By using a custom handle, install the handle in the position of your choosing with counter sunk screw
holes prior to installing the overlay panel to door.
Note: Optional Titan Handle is sold
separately, please contact below to inquire:
[e-mail]
Titan Contemporary Handle (sold separately)