Operation Manual

25CC PETROL MULTI TOOL TTK587GDO

BRUSH CUTTER/GRASS TRIMMER GUARD ASSEMBLY

The safety guard for the brush cutter and grass trimmer comes in two separate parts, to be

adapted dependent on purpose.

Brush Cutter Guard Assembly

1. Loosen the three pre-assembled screws on the gear head (Fig.3).

Fig. 3

2. Rotate the backing flange (B4) until one of the notches is aligned with the hole in the gear

head.

3. Insert the spindle lock rod (E3) into the hole to lock the spindle (B2).

4. Pull the safety pin (B8) out, loosen the safety nut (B7) and take it off together with the

locking flange (B6) and backing flange (B4) (Fig.4)

5. Place the cutting guard (B3) onto the support and fix it with the screws by using the Torx

screwdriver (E3). Pay attention to the alignment of the cutting guard. (See Fig. 5)

Fig. 4

Fig. 5