Operation Manual

25CC PETROL MULTI TOOL TTK587GDO

If you intend to use the product as brush cutter, proceed to "Brush cutter assembly".

Grass Trimmer Guard Assembly

If you intend to use the product as grass trimmer additionally attach the trimming guard (B9).

Fix the trimming guard (B9) and with three fixed bolts by using the hex key (E4) (See Fig. 6).

Then proceed as per "Grass trimmer assembly" below.

fixed bolt

Fig. 6

BRUSH CUTTER BLADE ASSEMBLY

1. Make sure that the cutting guard (B3) has been attached properly and the screws have

been removed from the outer edge.

2. Put the backing flange (B4) onto the spindle (B2).

3. Fit the blade (B5) to the spindle (B2). The rotational direction indicated on the guard and

that of the blade must agree. Ensure that the blade sits securely on the extruded ring on

the backing flange.

4. Put the locking flange (B6) onto the blade (B5). The pins must engage in the hole on the

backing flange (B4).

5. Insert the spindle lock rod (E3) into the hole to lock the spindle. Screw the safety nut (B7)

by use the spark plug wrench (E2) anti-clockwise. Remove the spindle lock rod (E3).

6. Secure the blade (B5) with the safety nut (B7) removed earlier and insert the pin (B8)

(See Fig. 7)

Fig. 7

GRASS TRIMMER ASSEMBLY

1. Make sure that the cutting guard (B3) and trimming guard (B9) have been attached

properly.

2. Put the backing flange (B4) onto the spindle (B2).

3. Rotate the backing flange (B4) until its hole is aligned with the notch in the gear head.

4. Insert the spindle lock rod (E3) into the hole to lock the spindle.

5. Screw the trimmer head (B11) on the spindle anti-clockwise (B2). (See Fig. 8)