Operation Manual

25CC PETROL MULTI TOOL TTK587GDO

NOTE: The pole extension should not be used with brush cutter/grass trimmer/hedge

trimmer accessories. The pole extension accessory should only be used with pole

pruner. If required, the pole extension can be fitted by following the same steps as

above.

3. Secure the connection by tightening the locking knob (A14) clockwise. (See Fig. 9c)

Fig. 9c

HEDGE TRIMMER ATTACHMENT

Hedge Trimmer Shaft

1. Loosen the two bolts (C3) on the joint and then align the hole of the hedge trimmer shaft

(C6). (See Fig. 10a)

Fig. 10a

2. Insert the shaft and secure the connection with the bolts by using the hex key (E5). (See

Fig. 10b)

Fig. 10b

POLE PRUNER ACCESSORY

The pole pruner accessory comes pre-assembled to the shaft. Additional assembly would

only be required if the pole extension is also required.

Saw Chain Tensioning

Always check the saw chain tension before use, after first cuts and regularly during use,

approx. every five cuts. After initial operation, new chains can lengthen considerably. This is

normal during the break-in period and the interval between future adjustments will lengthen

quickly.