Operation Manual

3. Move the hedge trimmer shaft (C6) with the other hand until the desired angle is adjusted.

(See Fig. 28c)

Fig. 28c

4. Release the unlock levers (C4) when the desired angle is adjusted. Ensure that the hook

engages between two teeth of the tooth wheel. (See Fig. 28d)

Fig. 28d

5. Make sure the unlock pin (C5) engages automatically and the joint is secured.

Trimming

1. Prepare the product to required length attaching the pole extensions and/or the hedge

trimmer shaft.

2. Cut and remove branches exceeding the cutting capacity of this product using a proper

pruner before operation.

3. Always hold the product firmly with both hands on gripping surface and handle grip (A17).

Never operate this product using only one hand.

4. Cut both sides from the bottom cutting upwards to the top. This will prevent any of the

cuttings falling into the path of the area still to be cut. (See Fig. 29a)

Fig.29a

25CC PETROL MULTI TOOL TTK587GDO