Operation Manual
5. Maintenance
WARNING! Always switch the product off, let the product cool down and disconnect
the spark plug connector before performing inspection, maintenance and cleaning
work!
WARNING! Only perform repairs and maintenance work according to these
instructions! All further works must be performed by a qualified specialist!
WARNING! Wear safety gloves when working on the attachment heads and close to
it! Use appropriate tools to remove debris, e.g. a brush or wooden stick! Never use
your bare hands!
Keep the product clean. Remove debris from it after each use and before storage.
Regular and proper cleaning will help ensure safe use and prolong the life of the product.
Inspect the product before each use for worn and damaged parts. Do not operate it if you find
broken and worn parts.
GENERAL CLEANING
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents or disinfectants
to clean this product as they might be harmful to its surfaces.
1. Clean the product with a slightly damp cloth and mild soap. Use a brush for areas that are
hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
4. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
Blade (Brush Cutter)
1. Keep the cutting blade (B5) clean and free of debris. Remove clippings.
2. Keep the cutting blade (B5) sharp to retain a good cutting performance. Replace a worn or
damaged cutting blade with a new one of the same type.
Trimmer Head
1. Keep the trimmer head (B11) clean and free of debris. Remove trimmings.
2. If the line is used up the spool must either be replaced by one of the same type or the
trimming line (B12) must be refilled.
3. To refill the trimming line lay the product on a flat stable surface with its trimmer head facing
upwards.
4. Rotate the backing flange until one of the notches is aligned with the hole in the gear head.
5. Insert the spindle lock rod (E3) into the hole to lock the spindle.
6. Remove the trimmer head (B11) by unscrewing clockwise. (See Fig. 34a)
Fig. 34a
47
25CC PETROL MULTI TOOL TTK587GDO
E3