Operation Manual

48
25CC PETROL MULTI TOOL TTK587GDO
7. To replace the spool simply remove from the trimmer head (B11) and replace with a new
one of the same type. (See Fig. 34b)
Fig. 34b
8. To replace the trimming line, press the release latch of the trimmer head housing to open
the cover.
9. Cut a new 6 m long trimming line with a diameter of 2 mm. Form a loop at the middle of the
line and insert this loop into the hook on the spool. (See Fig. 34c)
Fig. 34c
10. Wind the two parts of the trimming line in clockwise direction firmly around the spool
each part in the guide on the spool. (See Fig. 34d)
Fig. 34d
11. Insert each end of the threads in the respective holes. The threads should stick out 150 mm
on each side.
12. Screw the bumper (B13) anti-clockwise until it is completely and safely locked.
13. Remove the spindle lock rod (E3).