Operation Manual
- Inspect for damage.
- Check and tighten any loose parts
- Have any damaged parts replaced or repaired with parts having equivalent specifications.
13. Stop the engine before
- Cleaning or when clearing a blockage,
- Checking, carrying out maintenance or working on the product,
- Adjusting the working position of the cutting device,
- Leaving the product unattended.
14. Ensure that the product is correctly located in a designated working position before
starting the engine.
15. While operating the product, always ensure that the operating position is safe and secure.
16. Do not operate the product with a damaged or excessively worn cutting cutting blades
chain or edges.
17. Keep the engine and silencer free of debris, leaves and excessive lubricant to reduce fire
hazards.
18. Always ensure that all handles and guards are fitted when using the product. Never
attempt to use an incomplete product or one fitted with an unauthorised modification.
19. Always use two hands to operate a product fitted with two handles.
20. Always be aware of your surroundings and stay alert for possible hazards of which you
may not be aware due to the noise of the product.
21. Always ensure that ventilation openings are kept clear of debris.
Operation
1. This product should not be used for any other purpose than described. Note that national
regulations can restrict the use of this product.
2. Working with this product is demanding; therefore, ensure you are physically and mentally
fit to complete the job safely. Do not use the product when you are tired, ill or under the
influence of alcohol or other drugs.
3. Pay attention to your posture; always use the provided harness and keep your back
straight. Do not overwork yourself. Take regular breaks to ensure concentrated work and
full control over the product.
4. Keep a firm footing and balance during operation. Always be sure of a safe and secure
operating position, whilst using the product. Never use the product standing on steps or a
ladder.
5. Always wear substantial footwear and long trousers while operating. Do not operate the
product when barefoot or wearing open sandals. Wear protective glasses or goggles.
6. Thoroughly inspect the area where the product is to be used and remove all objects which
can be thrown by the product.
7. Before using the product and after any impact, check for signs of wear or damage and
repair as necessary.
8. Never operate the product with damaged guards or without the guards in place.
9. Keep hands and feet away from the cutting means at all times, and especially when
switching on the motor.
10. Never allow children or people unfamiliar with the instructions to use the product.
11. Stop using the product while people, especially children, or pets are nearby.
12. Only use the product in daylight or good artificial light.
07
25CC PETROL MULTI TOOL TTK587GDO