User's Manual

Copyright © 2022
P a g e | 20
5 CONFIGURATION
The HRD28000 reader can be configured using a command line interface or a web server. A command
line connection is established by opening a TCP/IP socket connection to port 50007 on the reader. To
enable specific protocols and antenna ports please refer to the User’s Manual on specifics for your
application.
5.1 COMMAND LINE
The HRD28000 reader supports the “C2” command line interface. This interface has various levels of
permission and allows the users to configure, test and operate the reader. Please refer to the User’s
Manual for more information.
5.2 WEB SERVER
The HRD28000 also supports an embedded web server which can be used in addition to the C2
command line interface. This web server can also be utilized for configuration, test and proper operation
of the reader. Please refer to the User’s Manual for more information.
5.3 LOGGING IN
5.3.1 Guest
The default initial login level upon opening a new command line connection is “guest” with default
password “guest”. A guest user is allowed to log in to a higher login level and view (but not change)
limited configuration settings.
5.3.2 Administrator
A guest user can upgrade their login level to “admin” with the command
“reader.login(admin,admin_password)”, where admin_password is the password for the
administrator account. The default password is “admin”. Please refer to the User’s Manual for
information on changing or resetting the password. An administrator account can change reader
configuration and fully operate the reader.
5.3.3 Installer
The Installer password can be found on the service card included with the HRD28000 reader. The
Installer is responsible for setting the correct regulatory mode, and in a licensed frequency installation,
the correct frequency. Please refer to the User’s Manual for more information.