SDS

Titebond Radon Sealant Gray
Section 6. Accidental release measures
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see
Section 1 for emergency contact information and Section 13 for waste disposal.
Large spill
:
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble. Alternatively, or if water-insoluble, absorb with an inert dry material and
place in an appropriate waste disposal container. Dispose of via a licensed waste
disposal contractor.
Small spill
:
Section 7. Handling and storage
Advice on general
occupational hygiene
Conditions for safe storage,
including any
incompatibilities
Eating, drinking and smoking should be prohibited in areas where this material is
handled, stored and processed. Workers should wash hands and face before eating,
drinking and smoking. Remove contaminated clothing and protective equipment before
entering eating areas. See also Section 8 for additional information on hygiene
measures.
Do not store below the following temperature: 5°C (41°F). Store in accordance with
local regulations. Store in original container protected from direct sunlight in a dry, cool
and well-ventilated area, away from incompatible materials (see Section 10) and food
and drink. Store locked up. Keep container tightly closed and sealed until ready for use.
Containers that have been opened must be carefully resealed and kept upright to
prevent leakage. Do not store in unlabeled containers. Use appropriate containment to
avoid environmental contamination. See Section 10 for incompatible materials before
handling or use.
:
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Avoid exposure -
obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Do not get in eyes or on skin or clothing. Do not breathe
vapor or mist. Do not ingest. If during normal use the material presents a respiratory
hazard, use only with adequate ventilation or wear appropriate respirator. Keep in the
original container or an approved alternative made from a compatible material, kept
tightly closed when not in use. Empty containers retain product residue and can be
hazardous. Do not reuse container.
:
Precautions for safe handling
ethanediol
OSHA PEL 1989 (United States, 3/1989).
CEIL: 50 ppm
CEIL: 125 mg/m³
ACGIH TLV (United States, 3/2017).
STEL: 10 mg/m³ 15 minutes. Form: Inhalable fraction. Aerosol only.
STEL: 50 ppm 15 minutes. Form: Vapor fraction
TWA: 25 ppm 8 hours. Form: Vapor fraction
Section 8. Exposure controls/personal protection
Ingredient name
Exposure limits
Appropriate engineering
controls
:
If user operations generate dust, fumes, gas, vapor or mist, use process enclosures,
local exhaust ventilation or other engineering controls to keep worker exposure to
airborne contaminants below any recommended or statutory limits.
Control parameters
Occupational exposure limits
Date of issue/Date of revision
:
6/18/2018
Version
:
1.1
4/11