User Manual

N o t e : O n e o f t h e a x i s d o e s n ’ t m o v e
T h e X - a x i s a n d Z - a x i s a r e O k b u t t h e Y- a x i s d o e s n o t m o v e ?
A:1.Check the connections; make sure it is plugged in correctly.
2.Check that the axis is not bending by turning the screw by hand (disconnect the router first).
3.Check that the grub screws on the coupler connecting the threaded rod to the stepper motor
are tight and the coupler is not slipping.
4.If this doesn’t work Please swap the X axis motor and Y axis motor cables. If the problem
moves to the X axis, the X axis driver chip has the problem. The control board should be
replaced.
6 . O p e n a t e s t G f i l e f o r e n g r a v i n g .
s t e p :
1 ) O p e n a t e s t G f i l e .
2 ) C l i c k J o g t o m o v e t h e s p i n d l e s o t h a t t h e B i t t o u c h e s t h e
s u r f a c e o f t h e e n g r a v e d p r o d u c t . ( 0 p o i n )
3 ) C l i c k Z e r o X Y a n d Z e r o t o r e s e t t h e c o o r d i n a t e o r i g i n .
4 ) C l i c k S e n d t o s t a r t c a r v i n g .
33