Use and Care Manual

14
PROBLEM POSSIBLE CAUSE SOLUTION
The light doe s not
work.
Not plugged in. Plug the cooler in.
The circuit breaker tri pped
or a blown fuse.
Check the breaker an d/or fuses.
The light button is “OFF”.
Press to turn the light ON.
Vibrations.
The cooler is not leveled. Check to assure th at t he cooler is le vel .
The bottles are vibratin g.
Make sure the bottl es don
’
t touch each
others.
There is an object under the
cooler.
Remove the object under the cooler.
The cooler seems to
make too muc
h
noise.
The cooler is not level. Level the cooler.
Normal noise from th e flow
of the refrigerant
The rattling noise may come from the flow
of the refrigerant, which is normal. As ea ch
cycle ends, you m a y hear gurgling sounds
caused by th e flo w of refrigerant in your
cooler. Contraction and expansion of the
inside walls may cause popping and
crackling noises.
The door will not
close properly.
The cooler is not level. Level the cooler.
The door was rever se d an d
not properly instal
led.
Re-install the door properly.
The gasket is dirty. Clean the door gasket .
The shelves are out of
position.
Place the shelves pro perly.
Moisture build up on
interior or
exterior of the
Beverage cooler.
This is normal during high
humidity periods.
Lower the room humidity.
This is normal i n high
temperature environment.
Move the cooler to a cooler place, and avoid
heat and sunlight.
Prolonged or frequent d oor
openings.
Open the door less often.
The door does not seal
compl
etely.
Check door gaskets for proper seal.
Error Code:
E1-E2-E3-E4-E7-E8
A sensor has fa i l ed. Contact the cust omer service