Use and Care Manual

7
Illustration #1 Illustration #2
To Install Your Beverage cooler
- This Be verage cooler is designed for free standing or built-in (full y recessed) installation.
- Place your Beverage cooler on a solid and level floor that is strong enough to support it when
it is ful ly loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling
legs in and out to stabilize the cooler horizo ntally. If the legs are not properly adjusted, the
cooler may be unstable and result in exce ss noise or vibration.
- Locate the Beverage cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc .). Direct sunligh t may affect the acrylic coating and heat sources m ay increase
electrical consump tion. Extremely cold ambient temperatures may also cause the cooler not
to perform properly.
- It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the components of your new cooler.
- It is recommended you install the Beverage cooler in a place with temperatures above 60°F
(15°C) and below 90°F (32°C), and humidity is under 60%. If the ambient temperature is
above or below recommend e d temperatures, the performance of the cooler may be affected.
Placing your cooler in extremely cold or hot conditions may cause interio r temperatures to
1 Gasket
2 Screw
3 Screw Driver
4 Handle
3
2
4