Owner`s manual

14. Only use attachments/accessories speciﬁed by the manufacturer.

15. Use only with the cart, stand, tripod, bracket, or table speciﬁed by the manu-

facturer, or sold with the apparatus. When a cart is used, use caution when mov-

ing the cart/apparatus combination to avoid injury from tip-over.

16. Refer all servicing to qualiﬁed service personnel. Servicing is required when

the apparatus has been damaged in any way, such as power-supply cord or plug is dam-

aged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has

been exposed to rain or moisture, does not operate normally, or has been dropped.

17. The radio must be located such that the rear AC socket and connected power cord are readily

accessible.

18. This product has been tested and found to comply with the limits for Part 15 of the FCC rules.

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that

this device does not cause harmful interference. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the product on and off, the

user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antennas.

• Increase the separation between the equipment and the receiver.

• Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

19. This Class B digital device complies with the Canadian ICES-003.

20. If an outside antenna or cable system is connected to the product, be sure the antenna or

cable system is grounded so as to provide some protection against voltage surges and built-up

static changes. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information

with regard to proper grounding of the mast and supporting structure, grounding of the lead-in

wire to an antenna discharge unit, size of grounding conductors, location of antenna-discharge.

unit, connection to grounding electrodes, and requirements for the grounding electrode.

See ﬁgure A.

21. For added protection for this product during a lightning storm, or when it is left unattended

and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna

or cable system. This will prevent damage to the product from lightning and power-line surges.

Figure A.