Owner`s manual

GUIDE TO FEATURES (REMOTE CONTROL)

1. POWER: Press brieﬂy to power the

Model 10 on. The radio will power on to

the last source used. Press to power the

Model 10 off.

2. MUTE/SNOOZE: Press to mute the audio

(the icon will ﬂash) while the unit is play-

ing; press again or adjust the volume to

restore sound. Press to mute the alarm

for 7 minutes after the alarm sounds. The

alarm will re-sound after 7 minutes. A

icon will show on the display when

Snooze is active. The Snooze time is

not adjustable.

3. ALARM: With the Model 10 powered on,

use the pq and Select buttons to adjust

and set the alarms. For a complete step-

by-step guide, refer to the section titled

“How to set the Alarm.”

4. SLEEP: Press to start the 20 minute

sleep timer. The display will indicate the

remaining sleep time and automatically

power the radio off after 20 minutes. A small clock face [ ] will show on the display when

the Sleep timer is active. Press again to cancel the sleep timer. The amount of sleep time is

not adjustable. Sleep can be activated regardless of whether the Model 10 is on or off.

5. SOURCE: Press to change sources.

6. INFO: Press repeatedly to view basic settings information.

7. PRESETS 1-5: Press and hold to store the currently tuned station. Press brieﬂy to recall the

station associated with that speciﬁc preset. The preset number will be indicated on the display.

There are 5 presets for the FM band and 5 presets for the AM band.

8. VOLUME +/–: Press the + button to raise the volume level or the – button to lower the volume

level. If the audio ever sounds distorted, lower the volume level to avoid damaging the speaker.

Adjusting the volume while the Model 10 is muted will cancel the muting.

9. pq/TUNE +/-: Press to adjust menu items. Use these same buttons to manually tune up or down

when in FM or AM mode. Press and hold to move quickly through the frequencies. A “T” will show

on the display to indicate manual tuning mode. It will take 2 or 3 seconds until the frequencies

begin to change. Press for 1.5 seconds and release to auto scan to the next station detected. The

display will show “–––.–– ” when auto scanning in FM and “ ––––” when auto scanning in AM.

10. : Press to navigate back or forward through the menu.

11. MENU/SELECT: Press to enter the main menu and press to select items within the menu. For

more, see the section marked “Menu”. Some of the menu items can be accessed regardless

of whether the Model 10 is on or off.

12. MONO: Press to change the Stereo/Mono setting. The display will show “M” for mono or

“ST” for stereo. “Mono” or “Stereo” will also be one of the ﬁelds shown when pressing the

Info button on the remote. This setting also affects the headphone output. For more, see the

section marked “FM/AM Reception”.

MONO