Owner`s manual

8
7. REC OUT: You can record from the Model One BT radio by connecting a cassette deck’s audio
input (or other recording device) to this fixed level stereo output. You can also use the Model
One BT radio as a high performance analog tuner by connecting it to the audio input of a
preamplifier or integrated amplifier. The primary speaker will not be muted when using this
output. This jack accepts a 1/8" stereo male mini connector.
8. 117V: Connect the included power cord to this input. When unplugging the power cord from the
wall outlet, always grab it by the plug. We recommend using a powerstrip with surge protection.
When disconnecting the power cord, always grasp it firmly at the connector. Never pull on the
cord itself. Do not bundle the power cord together with the external FM antenna or any audio
cables, as this can inject noise in the audio path.
BLUETOOTH
®
OPERATION
Prior to pairing, verify your device supports Bluetooth 2.1+EDR A2DP and your device is not
connected to any other Bluetooth product. Devices may pair differently. Below is a general guide.
1. Turn on the Model One BT to the Auxiliary position. This will power on the Bluetooth. Turn the volume
up about ¼ to start. Also turn up the volume on the source device (the device you are streaming from).
2. Turn on the Bluetooth wireless technology on your enabled device.
3. Select “Tivoli Bluetooth (Not Paired)” when it appears on your device’s screen to initiate searching.
Some devices may prompt you for a PIN. If so, enter “0000”. “Tivoli Bluetooth” will change from
“Not Paired” to “Connected”.
4. You will hear a ring tone from the Model One BT confirming connection and you can begin playing
your music files wirelessly. Adjust the volume level on your device. You should not have to pair
your device again. Depending on your device, you may need to make multiple attempts at
Pairing and/or Connecting to the Model One BT, but please give your device adequate
time to Pair or Connect before repeating the process.
PAIRING A BLUETOOTH
®
WIRELESS TECHNOLOGY ENABLED
iPhone
®
/iPod touch
®
/iPad
®
1. Turn on the Model One BT to the Auxiliary position. This will power on the Bluetooth. Turn the volume
up about ¼ to start. Also turn up the volume on the source device (the device you are streaming from)
2. Select “Settings”.
3. Select “General”.
4. Select “Bluetooth”.
5. Switch Bluetooth “On” to initiate searching.
6. Select “Tivoli Bluetooth (Not Paired)” when it appears on the display. If you are prompted to
enter a PIN, enter “0000”. “Tivoli Bluetooth” will change from “Not Paired” to “Connected”.
7. You will hear a ring tone from the Model One BT and you can begin playing your music files wirelessly.
Adjust the volume level on your device. You should not have to pair your iPhone
®
/iPod
®
/iPad
®
again.
The volume output level of music files varies. If you prefer an even higher output level, check the settings
in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off, and the Volume limit Off.
If you encounter a problem Pairing, press the small arrow to the right of “Tivoli Bluetooth” on your
iPhone/iPod touch/iPad display and select “Forget this Device”, then repeat the Pairing process.