Owner`s manual

11 – ENGLISH

3. Select “General”.

4. Select “Bluetooth”.

5. Switch Bluetooth “On” to initiate searching.

Select “Tivoli Bluetooth (Not Paired)” when it appears on the display. If you are prompted to enter

a PIN, enter “0000”. “Tivoli Bluetooth” will change from “Not Paired” to “Connected”.

7. You will hear a ring tone from the Music System Two and you can begin playing your music ﬁles

wirelessly. Adjust the volume level on your device. You should not have to pair your iPhone/

iPod/iPad again.

The volume output level of music ﬁles varies. If you prefer an even higher output level, check the set-

tings in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off, and the Volume limit Off.

If you encounter a problem Pairing, press the small arrow to the right of “Tivoli Bluetooth” on your

iPhone/iPod touch/iPad display and select “Forget this Device”, then repeat the Pairing process.

Depending on your device, you may need to make multiple attempts at Pairing and/or Con-

necting to the Music System Two, but please give your device adequate time to Pair or Connect

before repeating the process.

When streaming music, you can press the blue arrow to the right of the next track button >>/ on the

iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and Bluetooth.

NOTE:

• The Music System Two will remember pairing information for up to 8 devices. Additional devices

can be paired, but the least-recently used device will be replaced by the newly paired device.

• If the audio drops out or stops during playback, move your device closer to the Music System

Two, or check to be sure another wireless device is not interfering with the signal.

• When switching from Bluetooth to AM or FM, you may need to re-adjust (lower) the radio’s

volume level.

Getting the most from your Music System Two

1. Treat the Music System Two as you would a home stereo system. Although the audio from a

computer or laptop can be connected to the Music System Two, it’s not intended for near-ﬁeld

(close-up) listening like “computer speakers”. As with a home stereo system, listening at a

distance will yield the best results.

The SpacePhase™ Wide mode and EQ settings allow you to tailor the Music System Two’s

sound to your liking depending on the program material, room size and volume level. We’ve

spent countless hours of critical listening using a variety of material with different settings and at

different volume levels. In general we recommend the treble control be kept in the “0” position.

At high volume levels, for the most accurate reproduction, we recommend keeping the EQ off

and the Audio setting in Stereo or Mono (not SpacePhase™ Wide) mode.

Should you ever experience a problem, remove the batteries and the power cord for 60 seconds,

then reinstall the batteries and re-attach the cord. This should restore normal operation.

Reception/RDS

The internal FM antenna (built into the power cord) will provide good FM reception. The supplied

external FM antenna will usually provide improved reception. Fully extend the antenna and do not

bundle it with the power cord or other cords. Locating the antenna near a window or outside wall

will provide better reception than more interior locations. An outdoor antenna will provide the best