Owner`s manual

6 – ENGLISH

Guide To Features (Front Panel)

MUSIC SYSTEM TWO

ALARM 1

ALARM 2

SOURCE

– TUNE +

CLOCK

SLEEP

4 5 6

AUDIO

POWER

1 2 3

8 11

7 4 1

10693

1. POWER: Push to power the Music System Two On or Off (Standby).

ALARM 1/ALARM 2: Brieﬂy press and hold Alarm 1 or 2. A beep will conﬁrm you are in the alarm

set-up mode and the corresponding green LED will illuminate. Rotate and press the Volume knob

in to adjust and set the hour (which also determines AM and PM (Figure 1) and minutes (Figure

2) and press in to set and move to the next setting. Note, adjusting the hour does not affect the

minutes and vise-versa. Set the alarm source (Figure 3 and 4) and alarm volume (Figure 5) in the

same manner. Setting the alarm source to “AUX” will cause the alarm to wake to a tone. When

the alarm LED is off, press the Alarm button once to set the alarm. The display will show the

time the alarm is set to wake. When the alarm LED is on, press the Alarm button brieﬂy to turn

it off. If the alarm is set and power is lost, the alarm will still sound (the tone will sound in place

of radio) at the designated time provided fresh batteries are correctly installed in the rear battery

compartment. When the alarm activates (Alarm LED ﬂashes) you may either turn the unit off and

keep the alarm set for the next day, press the Snooze button to temporarily mute the alarm for 7

minutes, or brieﬂy press the Alarm button to cancel activation,turning the unit off, and keeping

the alarm set to wake the next day.

Fig 1, 2, 3, 4, 5

3. PRESETS 1–6: Press and hold to memorize the tuned station to that particular preset. A beep

will sound conﬁrming the station has been successfully stored. Press brieﬂy to recall the sta-

tion associated with that preset. There are 6 FM presets and 6 AM presets. If a Preset button is

pressed but no station has been set, the display will show “Preset Empty” for 2 seconds. The

same station cannot be saved to more than 1 preset.

4. SOURCE: Brieﬂy press to cycle through the four sources: FM, AM, Auxiliary, and Bluetooth. The

source can’t be changed while the alarm is sounding.