Owner`s manual

9
may be scrambled. Note the AM band does not utilize RDS text. For more, see “Reception/
RDS”. RDS text will not be shown in Sleep mode. When playing a CD, press repeatedly to
select between CD Scrolling Text, Static Text, or CD Text Off. If the inserted CD does not
contain CD text (Figure 12), then this feature cannot be enabled. Not all commercial music
CDs contain CD Text. CD text will not be shown in Sleep mode.
15. SNOOZE/MUTE (Top of Cabinet): When the Alarm activates, press this button to silence
the alarm for 7 minutes. The display will count down the remaining Snooze time. Adjusting
the volume level will cancel the Snooze mode. During normal operation, press this button
to mute the audio. The display will show “Mute”. Press again to restore the audio output
or adjust the volume level.
16. HEADPHONE OUT: Connect a set of headphones (not included) to this variable stereo
output for private listening. Plugging in the headphones will mute the primary speakers.
The headphone’s volume is adjusted using the front panel volume knob. This stereo output
accepts a 1/8" stereo male mini connector. Avoid using headphones at high volume levels
to prevent possible hearing damage.
17. OPTICAL SENSOR: Automatically adjusts the display brightness based on ambient lighting
conditions. The display will dim in darker environments and brighten in brighter conditions.
Do not obstruct this sensor.
18. IR SENSOR: Receives signals from the included remote control. Do not obstruct this sensor.
19. SLOT-LOAD: Insert a disc (with printing side facing up) until it is drawn inside. The display
will say “Loading”. Disc functions will not work while the disc is loading. Playback will begin
automatically once the table of contents is read. The display will show “No Disc” when the
unit is set to CD mode and there is no CD inside. When ejecting a CD the display will show
“Ejecting”. For more, see “Important Notes About the CD Player.”
Getting the most from your Music System:
1. Treat the Music System as you would a home stereo system. Although the audio from a
computer or laptop can be connected to the Music System, it’s not intended for near-field
(close-up) listening like “computer speakers”. As with a home stereo system, listening at a
distance will yield the best results.
2. The SpacePhase
™
Wide mode and EQ settings allow you to tailor the Music System’s
sound to your liking depending on the program material, room size and volume level. We’ve
spent countless hours of critical listening using a variety of material with different settings
and at different volume levels. In general we recommend the treble control be kept in the
“0” position. At high volume levels, for the most accurate reproduction, we recommend
keeping the EQ off and the Audio setting in Stereo or Mono (not SpacePhase
™
Wide) mode.
3. Should you ever experience a problem, remove the batteries and the power cord for 60
seconds, then reinstall the batteries and re-attach the cord. This should restore normal op-
eration. You can also try a factory re-set by simultaneously pressing and holding the clock,
alarm 1, and alarm 2 buttons. Note: this will erase stored settings.