Owner`s manual

a device is connected to the USB input, the LCD will brieﬂy show “USB unsupported” and might

not charge. To play these MP3 players, including the iPod, connect the player’s headphone out-

put to the NetWorks Auxiliary input and charge the device (if necessary) through other means. If

a Real music ﬁle will not play, it should be converted to MP3, WMA, or AAC format for playback

through the NetWorks.

6. PRESETS #1-5, SOURCE, MENU/SELECT, pqt u:

See “Guide to Features (Remote Control)”.

Guide to features (Bottom):

1. 12VDC/1A: Connect an optional external power supply to this input, or use an optional 1A

fused, 12VDC adaptor for operation in a boat or camper. The connector must be 5.5mm/2.1mm

center positive. It is normal for the external power supply to become warm during use. This

input should never be used simultaneously with the power cord input.

2. AUX IN: To hear audio from another device such as a CD or MP3 player, connect said device’s

audio output to this 3.5mm female stereo input. Note: You may need to adjust the volume

level differently for an auxiliary device than the level used for radio listening.

3. MIX IN: Connect the audio output from a computer to this 3.5mm female stereo input. The

computer’s audio will be mixed in with the audio from whatever source the NetWorks is in.

The volume level of the computer’s audio is controlled by the computer.

4. SUB OUT: Connect one end of the audio cable included with Tivoli Audio’s Model Subwoofer

(not included) to this 3.5mm female output.

5. REC OUT: To record from the NetWorks, connect the inputs from a recording device (such as

a cassette deck) to this 3.5mm female stereo ﬁxed output.

6. ETHERNET: If a WiFi signal is unavailable or is unreliable, securely connect a standard Ethernet

cable (not included) to this input.

7. R-SPR: Connect the male RCA from the optional NetWorks Speaker to this female RCA output,

adjust the Balance control to the center detent position, and place the Mono/Stereo switch in the

Stereo position. Bend the NetWorks Speaker connecting cable so the NetWorks radio sits ﬂush.

8. POWER CORD INPUT: Insert the correct end of the included power cord securely into this

input and connect the other end of the cord into an electrical outlet. Damage as a result of us-

ing the NetWorks with an incorrect voltage is not covered by the factory warranty.

Helpful hint: When connecting mini cables (not included) to the bottom inputs and outputs,

bend the cables so the NetWorks sits ﬂush.

Be sure the NetWorks is turned off when connecting/disconnecting audio cables.

ETHERNET

SUB OUT REC OUT MIX IN AUX IN

R-SPR

12VDC

1000mA